The SAVE command uses the async command interface over the PF.
Upon a failure in the firmware -EREMOTEIO is returned.
In that case call mlx5_cmd_out_err() to let it print the command failure
details including the firmware syndrome.
Note:
The other commands in the driver use the sync command interface in a way
that a firmware syndrome is printed upon an error inside mlx5_core.
Signed-off-by: Yishai Hadas <yishaih@xxxxxxxxxx>
---
drivers/vfio/pci/mlx5/cmd.c | 7 ++++++-
1 file changed, 6 insertions(+), 1 deletion(-)
diff --git a/drivers/vfio/pci/mlx5/cmd.c b/drivers/vfio/pci/mlx5/cmd.c
index 8a39ff19da28..6b45bd7d89ad 100644
--- a/drivers/vfio/pci/mlx5/cmd.c
+++ b/drivers/vfio/pci/mlx5/cmd.c
@@ -614,8 +614,13 @@ static void mlx5vf_save_callback(int status, struct mlx5_async_work *context)
err:
/* The error flow can't run from an interrupt context */
- if (status == -EREMOTEIO)
+ if (status == -EREMOTEIO) {
status = MLX5_GET(save_vhca_state_out, async_data->out, status);
+ /* Failed in FW, print cmd out failure details */
+ mlx5_cmd_out_err(migf->mvdev->mdev, MLX5_CMD_OP_SAVE_VHCA_STATE, 0,
+ async_data->out);
+ }
+
async_data->status = status;
queue_work(migf->mvdev->cb_wq, &async_data->work);
}
--
2.18.1
