On Tue, Oct 17, 2023 at 9:59 AM Raghavendra Rao Ananta
<rananta@xxxxxxxxxx> wrote:
>
> Hi Eric,
> On Tue, Oct 17, 2023 at 2:23 AM Eric Auger <eauger@xxxxxxxxxx> wrote:
> >
> > Hi,
> > On 10/16/23 23:28, Raghavendra Rao Ananta wrote:
> > > On Mon, Oct 16, 2023 at 12:45 PM Eric Auger <eauger@xxxxxxxxxx> wrote:
> > >>
> > >> Hi Raghavendra,
> > >>
> > >> On 10/10/23 01:08, Raghavendra Rao Ananta wrote:
> > >>> From: Reiji Watanabe <reijiw@xxxxxxxxxx>
> > >>>
> > >>> On vCPU reset, PMCNTEN{SET,CLR}_EL0, PMINTEN{SET,CLR}_EL1, and
> > >>> PMOVS{SET,CLR}_EL1 for a vCPU are reset by reset_pmu_reg().
> > >> PMOVS{SET,CLR}_EL0?
> > > Ah, yes. It should be PMOVS{SET,CLR}_EL0.
> > >
> > >>> This function clears RAZ bits of those registers corresponding
> > >>> to unimplemented event counters on the vCPU, and sets bits
> > >>> corresponding to implemented event counters to a predefined
> > >>> pseudo UNKNOWN value (some bits are set to 1).
> > >>>
> > >>> The function identifies (un)implemented event counters on the
> > >>> vCPU based on the PMCR_EL0.N value on the host. Using the host
> > >>> value for this would be problematic when KVM supports letting
> > >>> userspace set PMCR_EL0.N to a value different from the host value
> > >>> (some of the RAZ bits of those registers could end up being set to 1).
> > >>>
> > >>> Fix this by clearing the registers so that it can ensure
> > >>> that all the RAZ bits are cleared even when the PMCR_EL0.N value
> > >>> for the vCPU is different from the host value. Use reset_val() to
> > >>> do this instead of fixing reset_pmu_reg(), and remove
> > >>> reset_pmu_reg(), as it is no longer used.
> > >> do you intend to restore the 'unknown' behavior at some point?
> > >>
> > > I believe Reiji's (original author) intention was to keep them
> > > cleared, which would still imply an 'unknown' behavior. Do you think
> > > there's an issue with this?
> > Then why do we bother using reset_unknown in the other places if
> > clearing the bits is enough here?
> >
> Hmm. Good point. I can bring back reset_unknown to keep the original behavior.
>
I had a brief discussion about this with Oliver, and it looks like we
might need a couple of additional changes for these register accesses:
- For the userspace accesses, we have to implement explicit get_user
and set_user callbacks that to filter out the unimplemented counters
using kvm_pmu_valid_counter_mask().
- For the guest accesses to be correct, we might have to apply the
same mask while serving KVM_REQ_RELOAD_PMU.
Thank you.
Raghavendra
> Thank you.
> Raghavendra
> > Thanks
> >
> > Eric
> > >
> > > Thank you.
> > > Raghavendra
> > >> Thanks
> > >>
> > >> Eric
> > >>>
> > >>> Signed-off-by: Reiji Watanabe <reijiw@xxxxxxxxxx>
> > >>> Signed-off-by: Raghavendra Rao Ananta <rananta@xxxxxxxxxx>
> > >>> ---
> > >>> arch/arm64/kvm/sys_regs.c | 21 +--------------------
> > >>> 1 file changed, 1 insertion(+), 20 deletions(-)
> > >>>
> > >>> diff --git a/arch/arm64/kvm/sys_regs.c b/arch/arm64/kvm/sys_regs.c
> > >>> index 818a52e257ed..3dbb7d276b0e 100644
> > >>> --- a/arch/arm64/kvm/sys_regs.c
> > >>> +++ b/arch/arm64/kvm/sys_regs.c
> > >>> @@ -717,25 +717,6 @@ static unsigned int pmu_visibility(const struct kvm_vcpu *vcpu,
> > >>> return REG_HIDDEN;
> > >>> }
> > >>>
> > >>> -static u64 reset_pmu_reg(struct kvm_vcpu *vcpu, const struct sys_reg_desc *r)
> > >>> -{
> > >>> - u64 n, mask = BIT(ARMV8_PMU_CYCLE_IDX);
> > >>> -
> > >>> - /* No PMU available, any PMU reg may UNDEF... */
> > >>> - if (!kvm_arm_support_pmu_v3())
> > >>> - return 0;
> > >>> -
> > >>> - n = read_sysreg(pmcr_el0) >> ARMV8_PMU_PMCR_N_SHIFT;
> > >>> - n &= ARMV8_PMU_PMCR_N_MASK;
> > >>> - if (n)
> > >>> - mask |= GENMASK(n - 1, 0);
> > >>> -
> > >>> - reset_unknown(vcpu, r);
> > >>> - __vcpu_sys_reg(vcpu, r->reg) &= mask;
> > >>> -
> > >>> - return __vcpu_sys_reg(vcpu, r->reg);
> > >>> -}
> > >>> -
> > >>> static u64 reset_pmevcntr(struct kvm_vcpu *vcpu, const struct sys_reg_desc *r)
> > >>> {
> > >>> reset_unknown(vcpu, r);
> > >>> @@ -1115,7 +1096,7 @@ static bool access_pmuserenr(struct kvm_vcpu *vcpu, struct sys_reg_params *p,
> > >>> trap_wcr, reset_wcr, 0, 0, get_wcr, set_wcr }
> > >>>
> > >>> #define PMU_SYS_REG(name) \
> > >>> - SYS_DESC(SYS_##name), .reset = reset_pmu_reg, \
> > >>> + SYS_DESC(SYS_##name), .reset = reset_val, \
> > >>> .visibility = pmu_visibility
> > >>>
> > >>> /* Macro to expand the PMEVCNTRn_EL0 register */
> > >>
> > >
> >
