Adds support for PreventHostIBS feature for SEV-ES and SNP guests.
Currently, the hypervisor is able to inspect instruction based samples
from the guest and gather execution information. With enablement of
PreventHostIBS feature, SEV-ES and SNP guests may choose to disallow
use of instruction based sampling by the hypervisor in order to limit
the information gathered about their execution. (More information in
Section 15.36.17 APM Volume 2)
While implementing this feature, unknown NMIs were being seen. On
further investigation, a race was found effecting the IBS FETCH/OP
MSR.
ENABLE bit and VALID bit for IBS_FETCH_CTL are contained in the same
MSR and same is the case with IBS_OP_CTL.
Consider the following scenario:
- The IBS MSR which has ENABLE bit set and VALID bit clear is read.
- During the process of clearing the ENABLE bit and writing the IBS
MSR to disable IBS, an IBS event can occur that sets the VALID bit.
- The write operation on IBS MSR can clear the newly set VALID bit.
- Since this situation is occurring in the CLGI/STGI window
(PreventHostIBS window), the actual NMI is not taken.
- Once VMRUN is issued, it will exit with VMEXIT_NMI and as soon as
STGI is executed, the pending NMI will trigger.
- The IBS NMI handler checks for the VALID bit to determine if the NMI
is generated because of IBS.
- Since VALID bit is now clear, it doesn't recognize that an IBS event
is occurred which in turn generates the dazed and confused unknown
NMI messages.
Per-cpu ibs_flags which indicates whether PreventHostIBS window is
active/inactive are added to avoid the above mentioned race.
An active PreventHostIBS window is set before calling VMRUN and
cleared after STGI. PreventHostIBS window check is added to
perf_ibs_handle_irq(), to avoid unknown NMIs and treat them as handled
when window is active.
There are 2 patches in this series.
1) Add amd_prevent_hostibs_window() function to set per-cpu ibs_flags
based on an active/inactive PreventHostIBS window.
2) Enable PreventHostIBS for SEV-ES and SNP guests.
Testing done:
- Executed program symbols in guest are not captured in host when
PreventHostIBS feature is enabled.
- Generated 1000+ NMIs using cpuid command, no unknown NMIs are seen
after enablement of PreventHostIBS feature.
Qemu commandline to enable PreventHostIBS on guest.
qemu-system-x86_64 -enable-kvm -cpu EPYC-v4,+nohostibs \ ..
Manali Shukla (2):
perf/x86/amd: Add amd_prevent_hostibs_window() to set per-cpu
ibs_flags
KVM: SEV: PreventHostIBS enablement for SEV-ES and SNP guest
arch/x86/events/amd/ibs.c | 64 ++++++++++++++++++++++++++++++
arch/x86/include/asm/cpufeatures.h | 1 +
arch/x86/include/asm/perf_event.h | 20 ++++++++++
arch/x86/kvm/svm/sev.c | 10 +++++
arch/x86/kvm/svm/svm.c | 39 +++++++++++++++++-
arch/x86/kvm/svm/svm.h | 1 +
6 files changed, 133 insertions(+), 2 deletions(-)
--
2.34.1
