On Wed, Aug 31, 2022, Maxim Levitsky wrote: > On Wed, 2022-08-31 at 08:59 +0300, Maxim Levitsky wrote: > > On Wed, 2022-08-31 at 00:34 +0000, Sean Christopherson wrote: > > > Remove SVM's so called "hybrid-AVIC mode" and reinstate the restriction > > > where AVIC is disabled if x2APIC is enabled. The argument that the > > > "guest is not supposed to access xAPIC mmio when uses x2APIC" is flat out > > > wrong. Activating x2APIC completely disables the xAPIC MMIO region, > > > there is nothing that says the guest must not access that address. > > > > > > Concretely, KVM-Unit-Test's existing "apic" test fails the subtests that > > > expect accesses to the APIC base region to not be emulated when x2APIC is > > > enabled. > > > > > > Furthermore, allowing the guest to trigger MMIO emulation in a mode where > > > KVM doesn't expect such emulation to occur is all kinds of dangerous. > > Also, unless I misunderstood you, the above statement is wrong. > > Leaving AVIC on, when vCPU is in x2apic mode cannot trigger extra MMIO emulation, > in fact the opposite - because AVIC is on, writes to 0xFEE00xxx might *not* trigger > MMIO emulation and instead be emulated by AVIC. That's even worse, because KVM is allowing the guest to exercise hardware logic that I highly doubt AMD has thoroughly tested. > Yes, some of these writes can trigger AVIC specific emulation vm exits, but they > are literaly the same as those used by x2avic, and it is really hard to see > why this would be dangerous (assuming that x2avic code works, and avic code > is aware of this 'hybrid' mode). The APIC_RRR thing triggered the KVM_BUG_ON() in kvm_apic_write_nodecode() precisely because of the AVIC trap. At best, this gives a way for the guest to trigger a WARN_ON_ONCE() and thus panic the host if panic_on_warn=1. I fixed the APIC_RRR case because that will be problematic for x2AVIC, but there are other APIC registers that are unsupported in x2APIC that can trigger the KVM_BUG_ON(). > From the guest point of view, unless the guest pokes at random MMIO area, > the only case when this matters is if the guest maps RAM over the 0xFEE00xxx > (which it of course can, the spec explictly state as you say that when x2apic > is enabled, the mmio is disabled), and then instead of functioning as RAM, > the range will still function as APIC. There is no wiggle room here though, KVM is blatantly breaking the architectural specification. When x2APIC is enabled, the xAPIC MMIO does not exist.
