> There are two uses of KVM_REQ_GET_NESTED_STATE_PAGES: > > 1. Defer loads when leaving SMM. > > 2: Defer loads for KVM_SET_NESTED_STATE. > > #1 is fully solvable without a request, e.g. split ->leave_smm() into two helpers, > one that restores whatever metadata is needed before restoring from SMRAM, and > a second to load guest virtualization state that _after_ restoring all other guest > state from SMRAM. > > #2 is done because of the reasons Jim listed above, which are specific to demand > paging (including userfaultfd). There might be some interactions with other > ioctls() (KVM_SET_SREGS?) that are papered over by the request, but that can be > solved without a full request since only the first KVM_RUN after KVM_SET_NESTED_STATE > needs to refresh things (though ideally we'd avoid that). Ack on the fact that the 2-step process is specific to demand paging. Currently, KVM_SET_NESTED_STATE is a two-step process in which the 1st step does not require vmcs12 to be ready. So, I am thinking about what it means to deprecate KVM_REQ_GET_NESTED_STATE_PAGES? For case #2, I think there might be two options if we deprecate it: - Ensuring vmcs12 ready during the call to ioctl(KVM_SET_NESTED_STATE). This requires, as Jim mentioned, that the thread who is listening to the remote page request ready to serve before this call (this is true regardless of uffd based or Google base demand paging). We definitely can solve this ordering problem, but that is beyond KVM scope. It basically requires our userspace to cooperate. - Ensuring vmcs12 ready before vmenter. This basically defers the vmcs12 checks to the last second. I think this might be a better one. However, isn't it the same as the original implementation, i.e., instead of using KVM_REQ_GET_NESTED_STATE_PAGES, we have to use some other flags to tell KVM to load a vmcs12? Thanks. -Mingwei > > In other words, if the demand paging use case goes away, then KVM can get rid of > KVM_REQ_GET_NESTED_STATE_PAGES. > > > KVM_SET_NESTED_STATE in VMX, while in SVM implementation, it is simply > > just a kvm_make_request(KVM_REQ_GET_NESTED_STATE_PAGES, vcpu); > > svm_set_nested_state() very rougly open codes enter_svm_guest_mode(). VMX could > do the same, but that may or may not be a net positive. > > > hmm... so is the nested_vmx_enter_non_root_mode() call in vmx > > KVM_SET_NESTED_STATE ioctl() still necessary? I am thinking that > > because the same function is called again in nested_vmx_run(). > > nested_vmx_run() is used only to emulate VMLAUNCH/VMRESUME and wont' be invoked > if the vCPU is already running L2 at the time of migration. Ack.
