Am 19.05.22 um 11:23 schrieb Pierre Morel:
On 5/19/22 11:01, Christian Borntraeger wrote:
Am 06.05.22 um 11:24 schrieb Pierre Morel:
We let the userland hypervisor know if the machine support the CPU
topology facility using a new KVM capability: KVM_CAP_S390_CPU_TOPOLOGY.
The PTF instruction will report a topology change if there is any change
with a previous STSI_15_1_2 SYSIB.
Changes inside a STSI_15_1_2 SYSIB occur if CPU bits are set or clear
inside the CPU Topology List Entry CPU mask field, which happens with
changes in CPU polarization, dedication, CPU types and adding or
removing CPUs in a socket.
The reporting to the guest is done using the Multiprocessor
Topology-Change-Report (MTCR) bit of the utility entry of the guest's
SCA which will be cleared during the interpretation of PTF.
To check if the topology has been modified we use a new field of the
arch vCPU to save the previous real CPU ID at the end of a schedule
and verify on next schedule that the CPU used is in the same socket.
We do not report polarization, CPU Type or dedication change.
I think we should not do this. When PTF returns with "has changed" the guest
Linux will rebuild its schedule domains. And this is a really expensive
operation as far as I can tell. And the host Linux scheduler WILL schedule
too often to other CPUs. So in essence this will result in Linux guests
rebuilding their scheduler domains all the time.
So remove the "previous CPU logic" for now and only trigger an MTCR when
userspace says so. (eg. on config changes). The idea was to have user
defined schedule domains. Following host schedule decisions will be
nearly impossible.
I guess you saw that the MTCR bit is set only if the previous and new CPU are on different sockets, like it is on the hardware, not on every scheduling to another CPU.
Yes, but even that happens too often as far as I can tell.
However this can easily be done in an enhancement, if ever, since it has no implication on the UAPI.
I change this for the next round.
Yes, lets defer that (we would need solid measurements).
