In X2APIC mode the Logical Destination Register is read-only,
which provides a fixed mapping between the logical and physical
APIC IDs. Therefore, there is no Logical APIC ID table in X2AVIC
and the processor uses the X2APIC ID in the backing page to create
a vCPU’s logical ID.
Therefore, add logic to check x2APIC mode before updating logical
APIC ID table.
Signed-off-by: Suravee Suthikulpanit <suravee.suthikulpanit@xxxxxxx>
---
arch/x86/kvm/svm/avic.c | 11 ++++++++++-
1 file changed, 10 insertions(+), 1 deletion(-)
diff --git a/arch/x86/kvm/svm/avic.c b/arch/x86/kvm/svm/avic.c
index 215d8a7dbc1d..55b3b703b93b 100644
--- a/arch/x86/kvm/svm/avic.c
+++ b/arch/x86/kvm/svm/avic.c
@@ -417,6 +417,10 @@ static int avic_ldr_write(struct kvm_vcpu *vcpu, u8 g_physical_id, u32 ldr)
bool flat;
u32 *entry, new_entry;
+ /* Note: x2AVIC does not use logical APIC ID table */
+ if (apic_x2apic_mode(vcpu->arch.apic))
+ return 0;
+
flat = kvm_lapic_get_reg(vcpu->arch.apic, APIC_DFR) == APIC_DFR_FLAT;
entry = avic_get_logical_id_entry(vcpu, ldr, flat);
if (!entry)
@@ -435,8 +439,13 @@ static void avic_invalidate_logical_id_entry(struct kvm_vcpu *vcpu)
{
struct vcpu_svm *svm = to_svm(vcpu);
bool flat = svm->dfr_reg == APIC_DFR_FLAT;
- u32 *entry = avic_get_logical_id_entry(vcpu, svm->ldr_reg, flat);
+ u32 *entry;
+
+ /* Note: x2AVIC does not use logical APIC ID table */
+ if (apic_x2apic_mode(vcpu->arch.apic))
+ return;
+ entry = avic_get_logical_id_entry(vcpu, svm->ldr_reg, flat);
if (entry)
clear_bit(AVIC_LOGICAL_ID_ENTRY_VALID_BIT, (unsigned long *)entry);
}
--
2.25.1
