On Mon, May 10, 2021, Tom Lendacky wrote: > On 5/10/21 11:10 AM, Sean Christopherson wrote: > > On Fri, May 07, 2021, Tom Lendacky wrote: > >> On 5/7/21 11:59 AM, Sean Christopherson wrote: > >>> Allow userspace to set CR0, CR4, CR8, and EFER via KVM_SET_SREGS for > >>> protected guests, e.g. for SEV-ES guests with an encrypted VMSA. KVM > >>> tracks the aforementioned registers by trapping guest writes, and also > >>> exposes the values to userspace via KVM_GET_SREGS. Skipping the regs > >>> in KVM_SET_SREGS prevents userspace from updating KVM's CPU model to > >>> match the known hardware state. > >> > >> This is very similar to the original patch I had proposed that you were > >> against :) > > > > I hope/think my position was that it should be unnecessary for KVM to need to > > know the guest's CR0/4/0 and EFER values, i.e. even the trapping is unnecessary. > > I was going to say I had a change of heart, as EFER.LMA in particular could > > still be required to identify 64-bit mode, but that's wrong; EFER.LMA only gets > > us long mode, the full is_64_bit_mode() needs access to cs.L, which AFAICT isn't > > provided by #VMGEXIT or trapping. > > Right, that one is missing. If you take a VMGEXIT that uses the GHCB, then > I think you can assume we're in 64-bit mode. But that's not technically guaranteed. The GHCB even seems to imply that there are scenarios where it's legal/expected to do VMGEXIT with a valid GHCB outside of 64-bit mode: However, instead of issuing a HLT instruction, the AP will issue a VMGEXIT with SW_EXITCODE of 0x8000_0004 ((this implies that the GHCB was updated prior to leaving 64-bit long mode). In practice, assuming the guest is in 64-bit mode will likely work, especially since the MSR-based protocol is extremely limited, but ideally there should be stronger language in the GHCB to define the exact VMM assumptions/behaviors. On the flip side, that assumption and the limited exposure through the MSR protocol means trapping CR0, CR4, and EFER is pointless. I don't see how KVM can do anything useful with that information outside of VMGEXITs. Page tables are encrypted and GPRs are stale; what else could KVM possibly do with identifying protected mode, paging, and/or 64-bit? > > Unless I'm missing something, that means that VMGEXIT(VMMCALL) is broken since > > KVM will incorrectly crush (or preserve) bits 63:32 of GPRs. I'm guessing no > > one has reported a bug because either (a) no one has tested a hypercall that > > requires bits 63:32 in a GPR or (b) the guest just happens to be in 64-bit mode > > when KVM_SEV_LAUNCH_UPDATE_VMSA is invoked and so the segment registers are > > frozen to make it appear as if the guest is perpetually in 64-bit mode. > > I don't think it's (b) since the LAUNCH_UPDATE_VMSA is done against reset- > state vCPUs. > > > > > I see that sev_es_validate_vmgexit() checks ghcb_cpl_is_valid(), but isn't that > > either pointless or indicative of a much, much bigger problem? If VMGEXIT is > > It is needed for the VMMCALL exit. > > > restricted to CPL0, then the check is pointless. If VMGEXIT isn't restricted to > > CPL0, then KVM has a big gaping hole that allows a malicious/broken guest > > userspace to crash the VM simply by executing VMGEXIT. Since valid_bitmap is > > cleared during VMGEXIT handling, I don't think guest userspace can attack/corrupt > > the guest kernel by doing a replay attack, but it does all but guarantee a > > VMGEXIT at CPL>0 will be fatal since the required valid bits won't be set. > > Right, so I think some cleanup is needed there, both for the guest and the > hypervisor: > > - For the guest, we could just clear the valid bitmask before leaving the > #VC handler/releasing the GHCB. Userspace can't update the GHCB, so any > VMGEXIT from userspace would just look like a no-op with the below > change to KVM. Ah, right, the exit_code and exit infos need to be valid. > - For KVM, instead of returning -EINVAL from sev_es_validate_vmgexit(), we > return the #GP action through the GHCB and continue running the guest. Agreed, KVM should never kill the guest in response to a bad VMGEXIT. That should always be a guest decision. > > Sadly, the APM doesn't describe the VMGEXIT behavior, nor does any of the SEV-ES > > documentation I have. I assume VMGEXIT is recognized at CPL>0 since it morphs > > to VMMCALL when SEV-ES isn't active. > > Correct. > > > > > I.e. either the ghcb_cpl_is_valid() check should be nuked, or more likely KVM > > The ghcb_cpl_is_valid() is still needed to see whether the VMMCALL was > from userspace or not (a VMMCALL will generate a #VC). Blech. I get that the GHCB spec says CPL must be provided/checked for VMMCALL, but IMO that makes no sense whatsover. If the guest restricts the GHCB to CPL0, then the CPL field is pointless because the VMGEXIT will only ever come from CPL0. Yes, technically the guest kernel can proxy a VMMCALL from userspace to the host, but the guest kernel _must_ be the one to enforce any desired CPL checks because the VMM is untrusted, at least once you get to SNP. If the guest exposes the GHCB to any CPL, then the CPL check is worthless because guest userspace can simply lie about the CPL. And exposing the GCHB to userspace completely undermines guest privilege separation since hardware doesn't provide the real CPL, i.e. the VMM, even it were trusted, can't determine the origin of the VMGEXIT.
