Hello. I'm having quite an.. unusable system here. It's not really a regresssion with 0.11.0, it was something similar before, but with 0.11.0 and/or 2.6.31 it become much worse. The thing is that after some uptime, kvm guest prints something like this: hrtimer: interrupt too slow, forcing clock min delta to 461487495 ns after which system (guest) speeed becomes very slow. The above message is from 2.6.31 guest running wiht 0.11.0 & 2.6.31 host. Before I tried it with 0.10.6 and 2.6.30 or 2.6.27, and the delta were a bit less than that: hrtimer: interrupt too slow, forcing clock min delta to 152222415 ns hrtimer: interrupt too slow, forcing clock min delta to 93629025 ns etc. Before, guest was just somewhat slow. But now, it reached the state when it's almost unusable. Especially "nice" it's visible in xterm (running on that guest): typing a single char in xterm results in it being displayed after 1..2 sec pause. With applications like web browser (where all the font rendering is done on the client and X server receives bitmap instead of a character code to draw, it isn't that bad. I suspect it's only happening with small network packets. The above message (with large min delta) occured after about 20 hours uptime. Similar (give or take) delays were observed previously as well. That to say, -- it's not something you notice immediately. The problem is quite consistent, that is, different guests shows it sooner or later. Right now I'm running 2.6.31-amd64 host, 32bit qemu-kvm-0.11.0, 2.6.31-i686 uniprocessor guest, virtio networking and block devices, kvm-clock is enabled. Similar configuration were used before (with different versions). The hardware is Phenom 9750 (4core) running on Amd780g/sb700 chipset. Any hints on what to do with all this? Thanks! /mjt -- To unsubscribe from this list: send the line "unsubscribe kvm" in the body of a message to majordomo@xxxxxxxxxxxxxxx More majordomo info at http://vger.kernel.org/majordomo-info.html
