This patch series add support for dirty log based on HW DBM. It works well under some migration test cases, including VM with 4K pages or 2M THP. I checked the SHA256 hash digest of all memory and they keep same for source VM and destination VM, which means no dirty pages is missed under hardware DBM. Some key points: 1. Only support hardware updates of dirty status for PTEs. PMDs and PUDs are not involved for now. 2. About *performance*: In RFC patch, I have mentioned that for every 64GB memory, KVM consumes about 40ms to scan all PTEs to collect dirty log. This patch solves this problem through two ways: HW/SW dynamic switch and Multi-core offload. HW/SW dynamic switch: Give userspace right to enable/disable hw dirty log. This adds a new KVM cap named KVM_CAP_ARM_HW_DIRTY_LOG. We can achieve this by change the kvm->arch.vtcr value and kick vCPUs out to reload this value to VCTR_EL2. Then userspace can enable hw dirty log at the begining and disable it when dirty pages is little and about to stop VM, so VM downtime is not affected. Multi-core offload: Offload the PT scanning workload to multi-core can greatly reduce scanning time. To promise we can complete in time, I use smp_call_fuction to realize this policy, which utilize IPI to dispatch workload to other CPUs. Under 128U Kunpeng 920 platform, it just takes about 5ms to scan PTs of 256 RAM (use mempress and almost all PTs have been established). And We dispatch workload iterately (every CPU just scan PTs of 512M RAM for each iteration), so it won't affect physical CPUs seriously. 3. About correctness: Only add DBM bit when PTE is already writable, so we still have readonly PTE and some mechanisms which rely on readonly PTs are not broken. 4. About PTs modification races: There are two kinds of PTs modification. The first is adding or clearing specific bit, such as AF or RW. All these operations have been converted to be atomic, avoid covering dirty status set by hardware. The second is replacement, such as PTEs unmapping or changement. All these operations will invoke kvm_set_pte finally. kvm_set_pte have been converted to be atomic and we save the dirty status to underlying bitmap if dirty status is coverred. Change log: v2: - Address Steven's comments. - Add support of parallel dirty log sync. - Simplify and merge patches of v1. v1: - Address Catalin's comments. Keqian Zhu (8): KVM: arm64: Set DBM bit for writable PTEs KVM: arm64: Scan PTEs to sync dirty log KVM: arm64: Modify stage2 young mechanism to support hw DBM KVM: arm64: Save stage2 PTE dirty status if it is covered KVM: arm64: Steply write protect page table by mask bit KVM: arm64: Add KVM_CAP_ARM_HW_DIRTY_LOG capability KVM: arm64: Sync dirty log parallel KVM: Omit dirty log sync in log clear if initially all set arch/arm64/include/asm/kvm_host.h | 5 + arch/arm64/include/asm/kvm_mmu.h | 43 ++++- arch/arm64/kvm/arm.c | 45 ++++- arch/arm64/kvm/mmu.c | 307 ++++++++++++++++++++++++++++-- arch/arm64/kvm/reset.c | 5 + include/uapi/linux/kvm.h | 1 + tools/include/uapi/linux/kvm.h | 1 + virt/kvm/kvm_main.c | 3 +- 8 files changed, 389 insertions(+), 21 deletions(-) -- 2.19.1
