Hi Drew,
On 3/9/20 11:56 AM, Andrew Jones wrote:
> On Mon, Mar 09, 2020 at 11:24:10AM +0100, Eric Auger wrote:
>> ipi_enable() code would be reusable for other interrupts
>> than IPI. Let's rename it setup_irq() and pass an interrupt
>> handler pointer.
>>
>> Signed-off-by: Eric Auger <eric.auger@xxxxxxxxxx>
>>
>> ---
>>
>> v2 -> v3:
>> - do not export setup_irq anymore
>> ---
>> arm/gic.c | 20 +++++++-------------
>> 1 file changed, 7 insertions(+), 13 deletions(-)
>>
>> diff --git a/arm/gic.c b/arm/gic.c
>> index fcf4c1f..abf08c7 100644
>> --- a/arm/gic.c
>> +++ b/arm/gic.c
>> @@ -34,6 +34,7 @@ static struct gic *gic;
>> static int acked[NR_CPUS], spurious[NR_CPUS];
>> static int bad_sender[NR_CPUS], bad_irq[NR_CPUS];
>> static cpumask_t ready;
>> +typedef void (*handler_t)(struct pt_regs *regs __unused);
>
> This is just irq_handler_fn, which is already defined in processor.h.
> We don't need the __unused, not since 6b07148d06b1 ("Replace -Wextra
> with a saner list of warning flags").
Shall I duplicate it into ./lib/arm/asm/processor.h as well?
Thanks
Eric
>
>>
>> static void nr_cpu_check(int nr)
>> {
>> @@ -215,20 +216,20 @@ static void ipi_test_smp(void)
>> report_prefix_pop();
>> }
>>
>> -static void ipi_enable(void)
>> +static void setup_irq(handler_t handler)
>> {
>> gic_enable_defaults();
>> #ifdef __arm__
>> - install_exception_handler(EXCPTN_IRQ, ipi_handler);
>> + install_exception_handler(EXCPTN_IRQ, handler);
>> #else
>> - install_irq_handler(EL1H_IRQ, ipi_handler);
>> + install_irq_handler(EL1H_IRQ, handler);
>> #endif
>> local_irq_enable();
>> }
>>
>> static void ipi_send(void)
>> {
>> - ipi_enable();
>> + setup_irq(ipi_handler);
>> wait_on_ready();
>> ipi_test_self();
>> ipi_test_smp();
>> @@ -238,7 +239,7 @@ static void ipi_send(void)
>>
>> static void ipi_recv(void)
>> {
>> - ipi_enable();
>> + setup_irq(ipi_handler);
>> cpumask_set_cpu(smp_processor_id(), &ready);
>> while (1)
>> wfi();
>> @@ -295,14 +296,7 @@ static void ipi_clear_active_handler(struct pt_regs *regs __unused)
>> static void run_active_clear_test(void)
>> {
>> report_prefix_push("active");
>> - gic_enable_defaults();
>> -#ifdef __arm__
>> - install_exception_handler(EXCPTN_IRQ, ipi_clear_active_handler);
>> -#else
>> - install_irq_handler(EL1H_IRQ, ipi_clear_active_handler);
>> -#endif
>> - local_irq_enable();
>> -
>> + setup_irq(ipi_clear_active_handler);
>> ipi_test_self();
>> report_prefix_pop();
>> }
>> --
>> 2.20.1
>>
