Paravirtualized Control Register pinning is a strengthened version of existing protections on the Write Protect, Supervisor Mode Execution / Access Protection, and User-Mode Instruction Prevention bits. The existing protections prevent native_write_cr*() functions from writing values which disable those bits. This patchset prevents any guest writes to control registers from disabling pinned bits, not just writes from native_write_cr*(). This stops attackers within the guest from using ROP to disable protection bits. https://web.archive.org/web/20171029060939/http://www.blackbunny.io/linux-kernel-x86-64-bypass-smep-kaslr-kptr_restric/ The protection is implemented by adding MSRs to KVM which contain the bits that are allowed to be pinned, and the bits which are pinned. The guest or userspace can enable bit pinning by reading MSRs to check which bits are allowed to be pinned, and then writing MSRs to set which bits they want pinned. Other hypervisors such as HyperV have implemented similar protections for Control Registers and MSRs; which security researchers have found effective. https://www.abatchy.com/2018/01/kernel-exploitation-4 We add a CR pin feature bit to the KVM cpuid, read only MSRs which guests use to identify which bits they may request be pinned, and CR pinned MSRs which contain the pinned bits. Guests can request that KVM pin bits within control register 0 or 4 via the CR pinned MSRs. Writes to the MSRs fail if they include bits that aren't allowed to be pinned. Host userspace may clear or modify pinned bits at any time. Once pinned bits are set, the guest may pin more allowed bits, but may never clear pinned bits. In the event that the guest vcpu attempts to disable any of the pinned bits, the vcpu that issued the write is sent a general protection fault, and the register is left unchanged. Pinning is not active when running in SMM. Entering SMM disables pinned bits, writes to control registers within SMM would therefore trigger general protection faults if pinning was enforced. The guest may never read pinned bits. If an attacker were to read the CR pinned MSRs, they might decide to preform another attack which would not cause a general protection fault. Should userspace expose the CR pining CPUID feature bit, it must zero CR pinned MSRs on reboot. If it does not, it runs the risk of having the guest enable pinning and subsequently cause general protection faults on next boot due to early boot code setting control registers to values which do not contain the pinned bits. When running with KVM guest support and paravirtualized CR pinning enabled, paravirtualized and existing pinning are setup at the same point on the boot CPU. Non-boot CPUs setup pinning upon identification. Guests using the kexec system call currently do not support paravirtualized control register pinning. This is due to early boot code writing known good values to control registers, these values do not contain the protected bits. This is due to CPU feature identification being done at a later time, when the kernel properly checks if it can enable protections. Most distributions enable kexec. However, kexec could be made boot time disableable. In this case if a user has disabled kexec at boot time the guest will request that paravirtualized control register pinning be enabled. This would expand the userbase to users of major distributions. Paravirtualized CR pinning will likely be incompatible with kexec for the foreseeable future. Early boot code could possibly be changed to not clear protected bits. However, a kernel that requests CR bits be pinned can't know if the kernel it's kexecing has been updated to not clear protected bits. This would result in the kernel being kexec'd almost immediately receiving a general protection fault. Security conscious kernel configurations disable kexec already, per KSPP guidelines. Projects such as Kata Containers, AWS Lambda, ChromeOS Termina, and others using KVM to virtualize Linux will benefit from this protection. The usage of SMM in SeaBIOS was explored as a way to communicate to KVM that a reboot has occurred and it should zero the pinned bits. When using QEMU and SeaBIOS, SMM initialization occurs on reboot. However, prior to SMM initialization, BIOS writes zero values to CR0, causing a general protection fault to be sent to the guest before SMM can signal that the machine has booted. Pinning of sensitive CR bits has already been implemented to protect against exploits directly calling native_write_cr*(). The current protection cannot stop ROP attacks which jump directly to a MOV CR instruction. Guests running with paravirtualized CR pinning are now protected against the use of ROP to disable CR bits. The same bits that are being pinned natively may be pinned via the CR pinned MSRs. These bits are WP in CR0, and SMEP, SMAP, and UMIP in CR4. Future patches could protect bits in MSRs in a similar fashion. The NXE bit of the EFER MSR is a prime candidate. John Andersen (2): KVM: X86: Add CR pin MSRs X86: Use KVM CR pin MSRs Documentation/virt/kvm/msr.txt | 38 +++++++++++++++++++++++ arch/x86/Kconfig | 9 ++++++ arch/x86/include/asm/kvm_host.h | 2 ++ arch/x86/include/asm/kvm_para.h | 10 +++++++ arch/x86/include/uapi/asm/kvm_para.h | 5 ++++ arch/x86/kernel/cpu/common.c | 5 ++++ arch/x86/kernel/kvm.c | 17 +++++++++++ arch/x86/kvm/cpuid.c | 3 +- arch/x86/kvm/x86.c | 45 ++++++++++++++++++++++++++++ 9 files changed, 133 insertions(+), 1 deletion(-) -- 2.21.0
