For ARM-based systems with a GICv3 ITS to provide interrupt isolation,
but hardware limitations which are worked around by having MSIs bypass
SMMU translation (e.g. HiSilicon Hip06/Hip07), VFIO neglects to check
for the IRQ_DOMAIN_FLAG_MSI_REMAP capability, (and thus erroneously
demands unsafe_interrupts) if a software-managed MSI region is absent.
Fix this by always checking for isolation capability at both the IRQ
domain and IOMMU domain levels, rather than predicating that on whether
MSIs require an IOMMU mapping (which was always slightly tenuous logic).
Signed-off-by: Robin Murphy <robin.murphy@xxxxxxx>
---
drivers/vfio/vfio_iommu_type1.c | 4 ++--
1 file changed, 2 insertions(+), 2 deletions(-)
diff --git a/drivers/vfio/vfio_iommu_type1.c b/drivers/vfio/vfio_iommu_type1.c
index 8549cb111627..2328be628f21 100644
--- a/drivers/vfio/vfio_iommu_type1.c
+++ b/drivers/vfio/vfio_iommu_type1.c
@@ -1265,8 +1265,8 @@ static int vfio_iommu_type1_attach_group(void *iommu_data,
INIT_LIST_HEAD(&domain->group_list);
list_add(&group->next, &domain->group_list);
- msi_remap = resv_msi ? irq_domain_check_msi_remap() :
- iommu_capable(bus, IOMMU_CAP_INTR_REMAP);
+ msi_remap = irq_domain_check_msi_remap() ||
+ iommu_capable(bus, IOMMU_CAP_INTR_REMAP);
if (!allow_unsafe_interrupts && !msi_remap) {
pr_warn("%s: No interrupt remapping support. Use the module param \"allow_unsafe_interrupts\" to enable VFIO IOMMU support on this platform\n",
--
2.12.2.dirty
