On 11/3/22 12:44 AM, Marc Zyngier wrote:
On Wed, 02 Nov 2022 16:11:07 +0000,
Sean Christopherson <seanjc@xxxxxxxxxx> wrote:
On Wed, Nov 02, 2022, Marc Zyngier wrote:
On Wed, 02 Nov 2022 14:29:26 +0000, Peter Xu <peterx@xxxxxxxxxx> wrote:
However I don't see anything stops a simple "race" to trigger like below:
recycle thread vcpu thread
-------------- -----------
if (!dirty_ring_soft_full) <--- not full
dirty_ring_push();
if (dirty_ring_soft_full) <--- full due to the push
set_request(SOFT_FULL);
clear_request(SOFT_FULL); <--- can wrongly clear the request?
Hmmm, well spotted. That's another ugly effect of the recycle thread
playing with someone else's toys.
But I don't think that's a huge matter, as it'll just let the vcpu to have
one more chance to do another round of KVM_RUN. Normally I think it means
there can be one more dirty GFN (perhaps there're cases that it can push >1
gfns for one KVM_RUN cycle? I never figured out the details here, but
still..) pushed to the ring so closer to the hard limit, but we have had a
buffer zone of KVM_DIRTY_RING_RSVD_ENTRIES (64) entries. So I assume
that's still fine, but maybe worth a short comment here?
I never know what's the maximum possible GFNs being dirtied for a KVM_RUN
cycle. It would be good if there's an answer to that from anyone.
This is dangerous, and I'd rather not go there.
It is starting to look like we need the recycle thread to get out of
the way. And to be honest:
+ if (!kvm_dirty_ring_soft_full(ring))
+ kvm_clear_request(KVM_REQ_DIRTY_RING_SOFT_FULL, vcpu);
seems rather superfluous. Only clearing the flag in the vcpu entry
path feels much saner, and I can't see anything that would break.
Thoughts?
I've no objections to dropping the clear on reset, I suggested it
primarily so that it would be easier to understand what action
causes the dirty ring to become not-full. I agree that the explicit
clear is unnecessary from a functional perspective.
The core of the issue is that the whole request mechanism is a
producer/consumer model, where consuming a request is a CLEAR
action. The standard model is that the vcpu thread is the consumer,
and that any thread (including the vcpu itself) can be a producer.
With this flag clearing being on a non-vcpu thread, you end-up with
two consumers, and things can go subtly wrong.
I'd suggest replacing this hunk with a comment saying that the request
will be cleared by the vcpu thread next time it enters the guest.
Thanks, Marc. I will replace the hunk of code with the following
comments, as you suggested, in next respin.
/*
* The request KVM_REQ_DIRTY_RING_SOFT_FULL will be cleared
* by the VCPU thread next time when it enters the guest.
*/
I will post v8 after Peter/Sean/Oliver take a look on [PATCH v7 4/9].
I think we're settled on other patches.
Thanks,
Gavin
_______________________________________________
kvmarm mailing list
kvmarm@xxxxxxxxxxxxxxxxxxxxx
https://lists.cs.columbia.edu/mailman/listinfo/kvmarm
