On Thu, Aug 04, 2022 at 05:41:38PM -0700, Ricardo Koller wrote: > Some registers like the PMOVS reset to an architecturally UNKNOWN value. > Most tests expect them to be reset (mostly zeroed) using pmu_reset(). > Add a pmu_reset() on all the tests that need one. > > As a bonus, fix a couple of comments related to the register state > before a sub-test. > > Reviewed-by: Eric Auger <eric.auger@xxxxxxxxxx> > Signed-off-by: Ricardo Koller <ricarkol@xxxxxxxxxx> > --- > arm/pmu.c | 6 ++++-- > 1 file changed, 4 insertions(+), 2 deletions(-) > > diff --git a/arm/pmu.c b/arm/pmu.c > index 4c601b05..12e7d84e 100644 > --- a/arm/pmu.c > +++ b/arm/pmu.c > @@ -826,7 +826,7 @@ static void test_overflow_interrupt(void) > write_regn_el0(pmevcntr, 1, PRE_OVERFLOW); > isb(); > > - /* interrupts are disabled */ > + /* interrupts are disabled (PMINTENSET_EL1 == 0) */ > > mem_access_loop(addr, 200, pmu.pmcr_ro | PMU_PMCR_E); > report(expect_interrupts(0), "no overflow interrupt after preset"); > @@ -842,7 +842,7 @@ static void test_overflow_interrupt(void) > isb(); > report(expect_interrupts(0), "no overflow interrupt after counting"); > > - /* enable interrupts */ > + /* enable interrupts (PMINTENSET_EL1 <= ALL_SET) */ > > pmu_reset_stats(); > > @@ -890,6 +890,7 @@ static bool check_cycles_increase(void) > bool success = true; > > /* init before event access, this test only cares about cycle count */ > + pmu_reset(); This and the other pmu_reset() call below break compilation on 32-bit arm, because there's no pmu_reset() defined for it. It'd probably be best if we actually implemented some sort of reset for arm, considering it's being called in common tests. Thanks, drew > set_pmcntenset(1 << PMU_CYCLE_IDX); > set_pmccfiltr(0); /* count cycles in EL0, EL1, but not EL2 */ > > @@ -944,6 +945,7 @@ static bool check_cpi(int cpi) > uint32_t pmcr = get_pmcr() | PMU_PMCR_LC | PMU_PMCR_C | PMU_PMCR_E; > > /* init before event access, this test only cares about cycle count */ > + pmu_reset(); > set_pmcntenset(1 << PMU_CYCLE_IDX); > set_pmccfiltr(0); /* count cycles in EL0, EL1, but not EL2 */ > > -- > 2.37.1.559.g78731f0fdb-goog > _______________________________________________ kvmarm mailing list kvmarm@xxxxxxxxxxxxxxxxxxxxx https://lists.cs.columbia.edu/mailman/listinfo/kvmarm
