Hi Will, On Tue, Apr 19, 2022 at 03:10:13PM +0100, Will Deacon wrote: > On Tue, Apr 19, 2022 at 02:51:05PM +0100, Alexandru Elisei wrote: > > The approach I've taken so far in adding support for SPE in KVM [1] relies > > on pinning the entire VM memory to avoid SPE triggering stage 2 faults > > altogether. I've taken this approach because: > > > > 1. SPE reports the guest VA on an stage 2 fault, similar to stage 1 faults, > > and at the moment KVM has no way to resolve the VA to IPA translation. The > > AT instruction is not useful here, because PAR_EL1 doesn't report the IPA > > in the case of a stage 2 fault on a stage 1 translation table walk. > > > > 2. The stage 2 fault is reported asynchronously via an interrupt, which > > means there will be a window where profiling is stopped from the moment SPE > > triggers the fault and when the PE taks the interrupt. This blackout window > > is obviously not present when running on bare metal, as there is no second > > stage of address translation being performed. > > Are these faults actually recoverable? My memory is a bit hazy here, but I > thought SPE buffer data could be written out in whacky ways such that even > a bog-standard page fault could result in uncoverable data loss (i.e. DL=1), > and so pinning is the only game in town. Ah, I forgot about that, I think you're right (ARM DDI 0487H.a, page D10-5177): "The architecture does not require that a sample record is written sequentially by the SPU, only that: [..] - On a Profiling Buffer management interrupt, PMBSR_EL1.DL indicates whether PMBPTR_EL1 points to the first byte after the last complete sample record. - On an MMU fault or synchronous External abort, PMBPTR_EL1 serves as a Fault Address Register." and (page D10-5179): "If a write to the Profiling Buffer generates a fault and PMBSR_EL1.S is 0, then a Profiling Buffer management event is generated: [..] - If PMBPTR_EL1 is not the address of the first byte after the last complete sample record written by the SPU, then PMBSR_EL1.DL is set to 1. Otherwise, PMBSR_EL1.DL is unchanged." Since there is no way to know the record size (well, unless PMSIDR_EL1.MaxSize == PMBIDR_EL1.Align, but that's not an architectural requirement), it means that KVM cannot restore the write pointer to the address of the last complete record + 1, to allow the guest to resume profiling without corrupted records. > > A funkier approach might be to defer pinning of the buffer until the SPE is > enabled and avoid pinning all of VM memory that way, although I can't > immediately tell how flexible the architecture is in allowing you to cache > the base/limit values. A guest can use this to pin the VM memory (or a significant part of it), either by doing it on purpose, or by allocating new buffers as they get full. This will probably result in KVM killing the VM if the pinned memory is larger than ulimit's max locked memory, which I believe is going to be a bad experience for the user caught unaware. Unless we don't want KVM to take ulimit into account when pinning the memory, which as far as I can goes against KVM's approach so far. Thanks, Alex _______________________________________________ kvmarm mailing list kvmarm@xxxxxxxxxxxxxxxxxxxxx https://lists.cs.columbia.edu/mailman/listinfo/kvmarm
