As we are aiming to be able to control whether we enable VHE or not, let's always drop down to EL1 first, and only then upgrade to VHE if at all possible. This means that if the kernel is booted at EL2, we always start with a nVHE init, drop to EL1 to initialise the the kernel, and only then upgrade the kernel EL to EL2 if possible (the process is obviously shortened for secondary CPUs). Signed-off-by: Marc Zyngier <maz@xxxxxxxxxx> --- arch/arm64/kernel/head.S | 38 ++---------------------------------- arch/arm64/kernel/hyp-stub.S | 19 ++++++++++++++++++ 2 files changed, 21 insertions(+), 36 deletions(-) diff --git a/arch/arm64/kernel/head.S b/arch/arm64/kernel/head.S index 28e9735302df..07445fd976ef 100644 --- a/arch/arm64/kernel/head.S +++ b/arch/arm64/kernel/head.S @@ -433,6 +433,7 @@ SYM_FUNC_START_LOCAL(__primary_switched) bl __pi_memset dsb ishst // Make zero page visible to PTW + bl switch_to_vhe #if defined(CONFIG_KASAN_GENERIC) || defined(CONFIG_KASAN_SW_TAGS) bl kasan_early_init #endif @@ -493,42 +494,6 @@ SYM_INNER_LABEL(init_el1, SYM_L_LOCAL) eret SYM_INNER_LABEL(init_el2, SYM_L_LOCAL) -#ifdef CONFIG_ARM64_VHE - /* - * Check for VHE being present. x2 being non-zero indicates that we - * do have VHE, and that the kernel is intended to run at EL2. - */ - mrs x2, id_aa64mmfr1_el1 - ubfx x2, x2, #ID_AA64MMFR1_VHE_SHIFT, #4 -#else - mov x2, xzr -#endif - cbz x2, init_el2_nvhe - - /* - * When VHE _is_ in use, EL1 will not be used in the host and - * requires no configuration, and all non-hyp-specific EL2 setup - * will be done via the _EL1 system register aliases in __cpu_setup. - */ - mov_q x0, HCR_HOST_VHE_FLAGS - msr hcr_el2, x0 - isb - - init_el2_state vhe - - isb - - mov_q x0, INIT_PSTATE_EL2 - msr spsr_el2, x0 - msr elr_el2, lr - mov w0, #BOOT_CPU_MODE_EL2 - eret - -SYM_INNER_LABEL(init_el2_nvhe, SYM_L_LOCAL) - /* - * When VHE is not in use, early init of EL2 and EL1 needs to be - * done here. - */ mov_q x0, INIT_SCTLR_EL1_MMU_OFF msr sctlr_el1, x0 @@ -623,6 +588,7 @@ SYM_FUNC_START_LOCAL(secondary_startup) /* * Common entry point for secondary CPUs. */ + bl switch_to_vhe bl __cpu_secondary_check52bitva bl __cpu_setup // initialise processor adrp x1, swapper_pg_dir diff --git a/arch/arm64/kernel/hyp-stub.S b/arch/arm64/kernel/hyp-stub.S index 6ffdc1f7778b..effa9c858014 100644 --- a/arch/arm64/kernel/hyp-stub.S +++ b/arch/arm64/kernel/hyp-stub.S @@ -184,3 +184,22 @@ SYM_FUNC_START(__hyp_reset_vectors) hvc #0 ret SYM_FUNC_END(__hyp_reset_vectors) + +/* + * Entry point to switch to VHE if deemed capable + */ +SYM_FUNC_START(switch_to_vhe) +#ifdef CONFIG_ARM64_VHE + // Need to have booted at EL2 + adr_l x1, __boot_cpu_mode + ldr w0, [x1] + cmp w0, #BOOT_CPU_MODE_EL2 + b.ne 1f + + // Turn the world upside down + mov x0, #HVC_VHE_RESTART + hvc #0 +1: +#endif + ret +SYM_FUNC_END(switch_to_vhe) -- 2.29.2 _______________________________________________ kvmarm mailing list kvmarm@xxxxxxxxxxxxxxxxxxxxx https://lists.cs.columbia.edu/mailman/listinfo/kvmarm
