On Wed, Feb 05, 2020 at 06:17:15PM -0800, Sean Christopherson wrote:
> On Wed, Feb 05, 2020 at 09:00:31PM -0500, Peter Xu wrote:
> > On Wed, Feb 05, 2020 at 03:55:33PM -0800, Sean Christopherson wrote:
> > > On Wed, Feb 05, 2020 at 04:49:52PM -0500, Peter Xu wrote:
> > > > On Tue, Jan 21, 2020 at 02:31:39PM -0800, Sean Christopherson wrote:
> > > > > Reallocate a rmap array and recalcuate large page compatibility when
> > > > > moving an existing memslot to correctly handle the alignment properties
> > > > > of the new memslot. The number of rmap entries required at each level
> > > > > is dependent on the alignment of the memslot's base gfn with respect to
> > > > > that level, e.g. moving a large-page aligned memslot so that it becomes
> > > > > unaligned will increase the number of rmap entries needed at the now
> > > > > unaligned level.
> > > > >
> > > > > Not updating the rmap array is the most obvious bug, as KVM accesses
> > > > > garbage data beyond the end of the rmap. KVM interprets the bad data as
> > > > > pointers, leading to non-canonical #GPs, unexpected #PFs, etc...
> > > > >
> > > > > general protection fault: 0000 [#1] SMP
> > > > > CPU: 0 PID: 1909 Comm: move_memory_reg Not tainted 5.4.0-rc7+ #139
> > > > > Hardware name: QEMU Standard PC (Q35 + ICH9, 2009), BIOS 0.0.0 02/06/2015
> > > > > RIP: 0010:rmap_get_first+0x37/0x50 [kvm]
> > > > > Code: <48> 8b 3b 48 85 ff 74 ec e8 6c f4 ff ff 85 c0 74 e3 48 89 d8 5b c3
> > > > > RSP: 0018:ffffc9000021bbc8 EFLAGS: 00010246
> > > > > RAX: ffff00617461642e RBX: ffff00617461642e RCX: 0000000000000012
> > > > > RDX: ffff88827400f568 RSI: ffffc9000021bbe0 RDI: ffff88827400f570
> > > > > RBP: 0010000000000000 R08: ffffc9000021bd00 R09: ffffc9000021bda8
> > > > > R10: ffffc9000021bc48 R11: 0000000000000000 R12: 0030000000000000
> > > > > R13: 0000000000000000 R14: ffff88827427d700 R15: ffffc9000021bce8
> > > > > FS: 00007f7eda014700(0000) GS:ffff888277a00000(0000) knlGS:0000000000000000
> > > > > CS: 0010 DS: 0000 ES: 0000 CR0: 0000000080050033
> > > > > CR2: 00007f7ed9216ff8 CR3: 0000000274391003 CR4: 0000000000162eb0
> > > > > Call Trace:
> > > > > kvm_mmu_slot_set_dirty+0xa1/0x150 [kvm]
> > > > > __kvm_set_memory_region.part.64+0x559/0x960 [kvm]
> > > > > kvm_set_memory_region+0x45/0x60 [kvm]
> > > > > kvm_vm_ioctl+0x30f/0x920 [kvm]
> > > > > do_vfs_ioctl+0xa1/0x620
> > > > > ksys_ioctl+0x66/0x70
> > > > > __x64_sys_ioctl+0x16/0x20
> > > > > do_syscall_64+0x4c/0x170
> > > > > entry_SYSCALL_64_after_hwframe+0x44/0xa9
> > > > > RIP: 0033:0x7f7ed9911f47
> > > > > Code: <48> 3d 01 f0 ff ff 73 01 c3 48 8b 0d 21 6f 2c 00 f7 d8 64 89 01 48
> > > > > RSP: 002b:00007ffc00937498 EFLAGS: 00000246 ORIG_RAX: 0000000000000010
> > > > > RAX: ffffffffffffffda RBX: 0000000001ab0010 RCX: 00007f7ed9911f47
> > > > > RDX: 0000000001ab1350 RSI: 000000004020ae46 RDI: 0000000000000004
> > > > > RBP: 000000000000000a R08: 0000000000000000 R09: 00007f7ed9214700
> > > > > R10: 00007f7ed92149d0 R11: 0000000000000246 R12: 00000000bffff000
> > > > > R13: 0000000000000003 R14: 00007f7ed9215000 R15: 0000000000000000
> > > > > Modules linked in: kvm_intel kvm irqbypass
> > > > > ---[ end trace 0c5f570b3358ca89 ]---
> > > > >
> > > > > The disallow_lpage tracking is more subtle. Failure to update results
> > > > > in KVM creating large pages when it shouldn't, either due to stale data
> > > > > or again due to indexing beyond the end of the metadata arrays, which
> > > > > can lead to memory corruption and/or leaking data to guest/userspace.
> > > > >
> > > > > Note, the arrays for the old memslot are freed by the unconditional call
> > > > > to kvm_free_memslot() in __kvm_set_memory_region().
> > > >
> > > > If __kvm_set_memory_region() failed, I think the old memslot will be
> > > > kept and the new memslot will be freed instead?
> > >
> > > This is referring to a successful MOVE operation to note that zeroing @arch
> > > in kvm_arch_create_memslot() won't leak memory.
> > >
> > > > >
> > > > > Fixes: 05da45583de9b ("KVM: MMU: large page support")
> > > > > Cc: stable@xxxxxxxxxxxxxxx
> > > > > Signed-off-by: Sean Christopherson <sean.j.christopherson@xxxxxxxxx>
> > > > > ---
> > > > > arch/x86/kvm/x86.c | 11 +++++++++++
> > > > > 1 file changed, 11 insertions(+)
> > > > >
> > > > > diff --git a/arch/x86/kvm/x86.c b/arch/x86/kvm/x86.c
> > > > > index 4c30ebe74e5d..1953c71c52f2 100644
> > > > > --- a/arch/x86/kvm/x86.c
> > > > > +++ b/arch/x86/kvm/x86.c
> > > > > @@ -9793,6 +9793,13 @@ int kvm_arch_create_memslot(struct kvm *kvm, struct kvm_memory_slot *slot,
> > > > > {
> > > > > int i;
> > > > >
> > > > > + /*
> > > > > + * Clear out the previous array pointers for the KVM_MR_MOVE case. The
> > > > > + * old arrays will be freed by __kvm_set_memory_region() if installing
> > > > > + * the new memslot is successful.
> > > > > + */
> > > > > + memset(&slot->arch, 0, sizeof(slot->arch));
> > > >
> > > > I actually gave r-b on this patch but it was lost... And then when I
> > > > read it again I start to confuse on why we need to set these to zeros.
> > > > Even if they're not zeros, iiuc kvm_free_memslot() will compare each
> > > > of the array pointer and it will only free the changed pointers, then
> > > > it looks fine even without zeroing?
> > >
> > > It's for the failure path, the out_free label, which blindy calls kvfree()
> > > and relies on un-allocated pointers being NULL. If @arch isn't zeroed, the
> > > failure path will free metadata from the previous memslot.
> >
> > IMHO it won't, because kvm_free_memslot() will only free metadata if
> > the pointer changed. So:
> >
> > - For succeeded kvcalloc(), the pointer will change in the new slot,
> > so kvm_free_memslot() will free it,
> >
> > - For failed kvcalloc(), the pointer will be NULL, so
> > kvm_free_memslot() will skip it,
>
> No. The out_free path iterates over all possible entries and would free
> pointers from the old memslot. It's still be wrong even if the very last
> kcalloc() failed as that allocation is captured in a local variable and
> only propagated to lpage_info on success.
>
> out_free:
> for (i = 0; i < KVM_NR_PAGE_SIZES; ++i) {
> kvfree(slot->arch.rmap[i]);
> slot->arch.rmap[i] = NULL;
> if (i == 0)
> continue;
>
> kvfree(slot->arch.lpage_info[i - 1]);
> slot->arch.lpage_info[i - 1] = NULL;
> }
> return -ENOMEM;
Ah right. These discussion does also prove that simplify the slot
free path is good, because it's easy to get confused. :)
>
> > - For untouched pointer, it'll be the same as the old, so
> > kvm_free_memslot() will skip it as well.
> >
> > >
> > > > > +
> > > > > for (i = 0; i < KVM_NR_PAGE_SIZES; ++i) {
> > > > > struct kvm_lpage_info *linfo;
> > > > > unsigned long ugfn;
> > > > > @@ -9867,6 +9874,10 @@ int kvm_arch_prepare_memory_region(struct kvm *kvm,
> > > > > const struct kvm_userspace_memory_region *mem,
> > > > > enum kvm_mr_change change)
> > > > > {
> > > > > + if (change == KVM_MR_MOVE)
> > > > > + return kvm_arch_create_memslot(kvm, memslot,
> > > > > + mem->memory_size >> PAGE_SHIFT);
> > > > > +
> > > >
> > > > Instead of calling kvm_arch_create_memslot() explicitly again here,
> > > > can it be replaced by below?
> > > >
> > > > diff --git a/virt/kvm/kvm_main.c b/virt/kvm/kvm_main.c
> > > > index 72b45f491692..85a7b02fd752 100644
> > > > --- a/virt/kvm/kvm_main.c
> > > > +++ b/virt/kvm/kvm_main.c
> > > > @@ -1144,7 +1144,7 @@ int __kvm_set_memory_region(struct kvm *kvm,
> > > > new.dirty_bitmap = NULL;
> > > >
> > > > r = -ENOMEM;
> > > > - if (change == KVM_MR_CREATE) {
> > > > + if (change == KVM_MR_CREATE || change == KVM_MR_MOVE) {
> > > > new.userspace_addr = mem->userspace_addr;
> > > >
> > > > if (kvm_arch_create_memslot(kvm, &new, npages))
> > >
> > > No, because other architectures don't need to re-allocate new metadata on
> > > MOVE and rely on __kvm_set_memory_region() to copy @arch from old to new,
> > > e.g. see kvmppc_core_create_memslot_hv().
> >
> > Yes it's only required in x86, but iiuc it also will still work for
> > ppc? Say, in that case ppc won't copy @arch from old to new, and
> > kvmppc_core_free_memslot_hv() will free the old, however it should
> > still work.
>
> No, calling kvm_arch_create_memslot() for MOVE will result in PPC leaking
> memory due to overwriting slot->arch.rmap with a new allocation.
Why? For the MOVE case, kvm_arch_create_memslot() will create a new
rmap for the "new" memslot. If the whole procedure succeeded,
kvm_free_memslot() will free the old rmap. If it failed,
kvm_free_memslot() will free the new rmap if !NULL. Looks fine?
--
Peter Xu
_______________________________________________
kvmarm mailing list
kvmarm@xxxxxxxxxxxxxxxxxxxxx
https://lists.cs.columbia.edu/mailman/listinfo/kvmarm
