On Tue, Nov 06, 2018 at 09:52:59AM +0000, Suzuki K Poulose wrote:
>
>
> On 06/11/2018 08:42, Christoffer Dall wrote:
> >On Mon, Nov 05, 2018 at 03:00:34PM +0000, Suzuki K Poulose wrote:
> >>
> >>
> >>On 02/11/18 14:25, Christoffer Dall wrote:
> >>>On Fri, Nov 02, 2018 at 11:02:38AM +0000, Suzuki K Poulose wrote:
> >>>>Hi
> >>>>
> >>>>On 02/11/18 07:53, Christoffer Dall wrote:
> >>>>>In attempting to re-construct the logic for our stage 2 page table
> >>>>>layout I found the reaoning in the comment explaining how we calculate
> >>>>>the number of levels used for stage 2 page tables a bit backwards.
> >>>>>
> >>>>>This commit attempts to clarify the comment, to make it slightly easier
> >>>>>to read without having the Arm ARM open on the right page.
> >>>>>
> >>>>>While we're at it, fixup a typo in a comment that was recently changed.
> >>>>>
> >>>>>Signed-off-by: Christoffer Dall <christoffer.dall@xxxxxxx>
> >>>>>---
> >>>>> arch/arm64/include/asm/stage2_pgtable.h | 17 ++++++++++-------
> >>>>> virt/kvm/arm/mmu.c | 2 +-
> >>>>> 2 files changed, 11 insertions(+), 8 deletions(-)
> >>>>>
> >>>>>diff --git a/arch/arm64/include/asm/stage2_pgtable.h b/arch/arm64/include/asm/stage2_pgtable.h
> >>>>>index d352f6df8d2c..9c387320b28c 100644
> >>>>>--- a/arch/arm64/include/asm/stage2_pgtable.h
> >>>>>+++ b/arch/arm64/include/asm/stage2_pgtable.h
> >>>>>@@ -31,15 +31,18 @@
> >>>>> /*
> >>>>> * The hardware supports concatenation of up to 16 tables at stage2 entry level
> >>>>>- * and we use the feature whenever possible.
> >>>>>+ * and we use the feature whenever possible, which means we resolve 4 bits of
> >>>>
> >>>>s/we resolve 4 bits/we resolve 4 additional bits/ ?
> >>>>
> >>>
> >>>yes
> >>>
> >>>>>+ * address at the entry level.
> >>>>> *
> >>>>>- * Now, the minimum number of bits resolved at any level is (PAGE_SHIFT - 3).
> >>>>>+ * This implies, the total number of page table levels required for
> >>>>>+ * IPA_SHIFT at stage2 expected by the hardware can be calculated using
> >>>>>+ * the same logic used for the (non-collapsable) stage1 page tables but for
> >>>>>+ * (IPA_SHIFT - 4).
> >>>>>+ *
> >>>>>+ * Note, the minimum number of bits resolved at any level is (PAGE_SHIFT - 3).
> >>>>
> >>>>May be we could improve it further by :
> >>>>
> >>>>s/resolved at any level/resolved at any *non-entry* level/
> >>>>
> >>>>as, we could resolve as small as 1 bit at the entry level.
> >>>>
> >>>>
> >>>
> >>>yes
> >>>
> >>>>> * On arm64, the smallest PAGE_SIZE supported is 4k, which means
> >>>>>- * (PAGE_SHIFT - 3) > 4 holds for all page sizes.
> >>>>>- * This implies, the total number of page table levels at stage2 expected
> >>>>>- * by the hardware is actually the number of levels required for (IPA_SHIFT - 4)
> >>>>>- * in normal translations(e.g, stage1), since we cannot have another level in
> >>>>>- * the range (IPA_SHIFT, IPA_SHIFT - 4).
> >>>>>+ * (PAGE_SHIFT - 3) > 4 holds for all page sizes
> >>>>>+ * and therefore we will need a minimum of two levels for stage2 in all cases.
> >>>>
> >>>>I think the above statement is misleading. The minimum number of
> >>>>levels has nothing to do with the concatenation.
> >>>
> >>>Architecturally surely it does? (The point of concatenation is to
> >>>reduce the minimal number of levels required.)
> >>>
> >>>Maybe you mean the minimum number of levels imposed by KVM here?
> >>>
> >>>>For e.g, we could
> >>>>still create a stage2 with 1 level (32bit IPA on 64K, 29bit + 3bit
> >>>>concatenated), going by the same rules above. The only reason why
> >>>>we limit the number of levels to 2, is to prevent splitting stage1 PMD
> >>>>huge mappings (which are quite common) at stage2.
> >>>>
> >>>
> >>>So I wasn't entirely clear what the comment was trying to say with the
> >>>"(PAGE_SHIFT - 3) > 4 holds for all page size" statement, so I though
> >>>that was there to show that we'll need a minimum of two levels, but
> >>>maybe that was written under the assumption of the limitations of
> >>>IPA_SHIFT (was KVM_PHYS_SIZE).
> >>
> >>See below.
> >>
> >>>
> >>>Since you wrote the original comment, and I couldn't correctly parse
> >>>that, and I apparently still didn't fully understand, can you suggest an
> >>>alternative wording?
> >>
> >>I think trying to over explain the concept has created more confusion.
> >>The whole paragraph is trying to prove that we only need :
> >>
> >> ARM64_HW_PGTABLE_LEVELS(IPA_SHIFT - 4)
> >>to map IPA_SHIFT bits at stage2 with maximum utilization of the
> >>concatenation at entry level.
> >
> >Yes, I think that comes across more clearly in my rewording up to the
> >"Note, ...".
>
> Yes it does and I prefer your version than mine.
>
> >
> >>
> >>Right now the comment tries to establish it via the hard route, by
> >>proving that there cannot be an intermediate level in the range
> >>[IPA_SHIFT, IPA_SHIFT - 4]. Or in other words :
> >>
> >>(ARM64_HW_PGTABLE_LEVELS(IPA_SHIFT - 4) + 1) >=
> >> ARM64_HW_PGTABLE_LEVELS(IPA_SHIFT)
> >>
> >>I don't know if it is worth the explanation and then causing further
> >>confusion.
> >
> >I think you're then actually trying to explain two things.
> >
> >First, we can get the number of levels by using the stage 1 calculation
> >and adjust for concatenation by subtracting 4 from the number of bits we
> >need to translate.
> >
> >Second, some further reasoning about *why* that is true.
> >
> >It remains unclear to me exactly what your point about
> > '(PAGE_SHIFT - 3) > 4'
> >is and how that supports the second point. Also I'm not entirely sure
> >why we need that.
>
> So, we have to prove that :
> x + 1 >= y, where :
Why do we have to prove that?
>
> x = ARM64_HW_PGTABLE_LEVELS(IPA_SHIFT - 4)
> y = ARM64_HW_PGTABLE_LEVELS(IPA_SHIFT)
>
> We can prove it by contradiction. i.e let us assume
> y > x + 1, => There is an additional level between,
> (y) and (x + 1), which implies, there is an intermediate
> level covering the "bits" of the input address in the
> range [IPA_SHIFT, IPA_SHIFT - 4]. But since we must
> resolve exactly (PAGE_SHIFT - 3) bits (9bits minimum) in an intermediate
> level, that level can't exist. And thus our assumption can never
> be true.
>
> I guess we don't need to go to that level of craziness, just to prove it
> formally.
>
I can follow the math to prove x + 1 >= y, but I'm not sure how that
helps me understand anything or how it relates to the architecture?
Are you trying to explain why the architecture works the way it does, or
prove a specific relationship between architectural concepts, or what is
it we're trying to achieve here?
Thanks,
Christoffer
_______________________________________________
kvmarm mailing list
kvmarm@xxxxxxxxxxxxxxxxxxxxx
https://lists.cs.columbia.edu/mailman/listinfo/kvmarm
