This series redesigns parts of KVM/ARM to optimize the performance on
VHE systems. The general approach is to try to do as little work as
possible when transitioning between the VM and the hypervisor. This has
the benefit of lower latency when waiting for interrupts and delivering
virtual interrupts, and reduces the overhead of emulating behavior and
I/O in the host kernel.
Patches 01 through 06 are not VHE specific, but rework parts of KVM/ARM
that can be generally improved. We then add infrastructure to move more
logic into vcpu_load and vcpu_put, we improve handling of VFP and debug
registers.
We then introduce a new world-switch function for VHE systems, which we
can tweak and optimize for VHE systems. To do that, we rework a lot of
the system register save/restore handling and emulation code that may
need access to system registers, so that we can defer as many system
register save/restore operations to vcpu_load and vcpu_put, and move
this logic out of the VHE world switch function.
We then optimize the configuration of traps. On non-VHE systems, both
the host and VM kernels run in EL1, but because the host kernel should
have full access to the underlying hardware, but the VM kernel should
not, we essentially make the host kernel more privileged than the VM
kernel despite them both running at the same privilege level by enabling
VE traps when entering the VM and disabling those traps when exiting the
VM. On VHE systems, the host kernel runs in EL2 and has full access to
the hardware (as much as allowed by secure side software), and is
unaffected by the trap configuration. That means we can configure the
traps for VMs running in EL1 once, and don't have to switch them on and
off for every entry/exit to/from the VM.
Finally, we improve our VGIC handling by moving all save/restore logic
out of the VHE world-switch, and we make it possible to truly only
evaluate if the AP list is empty and not do *any* VGIC work if that is
the case, and only do the minimal amount of work required in the course
of the VGIC processing when we have virtual interrupts in flight.
The patches are based on v4.15-rc3, v9 of the level-triggered mapped
interrupts support series [1], and the first five patches of James' SDEI
series [2].
I've given the patches a fair amount of testing on Thunder-X, Mustang,
Seattle, and TC2 (32-bit) for non-VHE testing, and tested VHE
functionality on the Foundation model, running both 64-bit VMs and
32-bit VMs side-by-side and using both GICv3-on-GICv3 and
GICv2-on-GICv3.
The patches are also available in the vhe-optimize-v3 branch on my
kernel.org repository [3]. The vhe-optimize-v3-base branch contains
prerequisites of this series.
Changes since v2:
- Rebased on v4.15-rc3.
- Includes two additional patches that only does vcpu_load after
kvm_vcpu_first_run_init and only for KVM_RUN.
- Addressed review comments from v2 (detailed changelogs are in the
individual patches).
Thanks,
-Christoffer
[1]: git://git.kernel.org/pub/scm/linux/kernel/git/cdall/linux.git level-mapped-v9
[2]: git://linux-arm.org/linux-jm.git sdei/v5/base
[3]: git://git.kernel.org/pub/scm/linux/kernel/git/cdall/linux.git vhe-optimize-v3
Christoffer Dall (40):
KVM: arm/arm64: Avoid vcpu_load for other vcpu ioctls than KVM_RUN
KVM: arm/arm64: Move vcpu_load call after kvm_vcpu_first_run_init
KVM: arm64: Avoid storing the vcpu pointer on the stack
KVM: arm64: Rework hyp_panic for VHE and non-VHE
KVM: arm/arm64: Get rid of vcpu->arch.irq_lines
KVM: arm/arm64: Add kvm_vcpu_load_sysregs and kvm_vcpu_put_sysregs
KVM: arm/arm64: Introduce vcpu_el1_is_32bit
KVM: arm64: Defer restoring host VFP state to vcpu_put
KVM: arm64: Move debug dirty flag calculation out of world switch
KVM: arm64: Slightly improve debug save/restore functions
KVM: arm64: Improve debug register save/restore flow
KVM: arm64: Factor out fault info population and gic workarounds
KVM: arm64: Introduce VHE-specific kvm_vcpu_run
KVM: arm64: Remove kern_hyp_va() use in VHE switch function
KVM: arm64: Don't deactivate VM on VHE systems
KVM: arm64: Remove noop calls to timer save/restore from VHE switch
KVM: arm64: Move userspace system registers into separate function
KVM: arm64: Rewrite sysreg alternatives to static keys
KVM: arm64: Introduce separate VHE/non-VHE sysreg save/restore
functions
KVM: arm/arm64: Remove leftover comment from kvm_vcpu_run_vhe
KVM: arm64: Unify non-VHE host/guest sysreg save and restore functions
KVM: arm64: Don't save the host ELR_EL2 and SPSR_EL2 on VHE systems
KVM: arm64: Change 32-bit handling of VM system registers
KVM: arm64: Rewrite system register accessors to read/write functions
KVM: arm64: Introduce framework for accessing deferred sysregs
KVM: arm/arm64: Prepare to handle deferred save/restore of SPSR_EL1
KVM: arm64: Prepare to handle deferred save/restore of ELR_EL1
KVM: arm64: Defer saving/restoring 64-bit sysregs to vcpu load/put on
VHE
KVM: arm64: Prepare to handle deferred save/restore of 32-bit
registers
KVM: arm64: Defer saving/restoring 32-bit sysregs to vcpu load/put
KVM: arm64: Move common VHE/non-VHE trap config in separate functions
KVM: arm64: Configure FPSIMD traps on vcpu load/put
KVM: arm64: Configure c15, PMU, and debug register traps on cpu
load/put for VHE
KVM: arm64: Separate activate_traps and deactive_traps for VHE and
non-VHE
KVM: arm/arm64: Get rid of vgic_elrsr
KVM: arm/arm64: Handle VGICv2 save/restore from the main VGIC code
KVM: arm/arm64: Move arm64-only vgic-v2-sr.c file to arm64
KVM: arm/arm64: Handle VGICv3 save/restore from the main VGIC code on
VHE
KVM: arm/arm64: Move VGIC APR save/restore to vgic put/load
KVM: arm/arm64: Avoid VGICv3 save/restore on VHE with no IRQs
Shih-Wei Li (1):
KVM: arm64: Move HCR_INT_OVERRIDE to default HCR_EL2 guest flag
arch/arm/include/asm/kvm_asm.h | 5 +-
arch/arm/include/asm/kvm_emulate.h | 21 +-
arch/arm/include/asm/kvm_host.h | 6 +-
arch/arm/include/asm/kvm_hyp.h | 4 +
arch/arm/kvm/emulate.c | 4 +-
arch/arm/kvm/hyp/Makefile | 1 -
arch/arm/kvm/hyp/switch.c | 16 +-
arch/arm64/include/asm/kvm_arm.h | 4 +-
arch/arm64/include/asm/kvm_asm.h | 18 +-
arch/arm64/include/asm/kvm_emulate.h | 74 +++-
arch/arm64/include/asm/kvm_host.h | 49 ++-
arch/arm64/include/asm/kvm_hyp.h | 32 +-
arch/arm64/include/asm/kvm_mmu.h | 2 +-
arch/arm64/kernel/asm-offsets.c | 2 +
arch/arm64/kvm/debug.c | 28 +-
arch/arm64/kvm/guest.c | 3 -
arch/arm64/kvm/hyp/Makefile | 2 +-
arch/arm64/kvm/hyp/debug-sr.c | 88 +++--
arch/arm64/kvm/hyp/entry.S | 9 +-
arch/arm64/kvm/hyp/hyp-entry.S | 41 +--
arch/arm64/kvm/hyp/switch.c | 404 +++++++++++++---------
arch/arm64/kvm/hyp/sysreg-sr.c | 192 ++++++++--
{virt/kvm/arm => arch/arm64/kvm}/hyp/vgic-v2-sr.c | 81 -----
arch/arm64/kvm/inject_fault.c | 24 +-
arch/arm64/kvm/regmap.c | 65 +++-
arch/arm64/kvm/sys_regs.c | 247 +++++++++++--
arch/arm64/kvm/sys_regs.h | 4 +-
arch/arm64/kvm/sys_regs_generic_v8.c | 4 +-
include/kvm/arm_vgic.h | 2 -
virt/kvm/arm/aarch32.c | 2 +-
virt/kvm/arm/arch_timer.c | 7 -
virt/kvm/arm/arm.c | 50 ++-
virt/kvm/arm/hyp/timer-sr.c | 44 +--
virt/kvm/arm/hyp/vgic-v3-sr.c | 244 +++++++------
virt/kvm/arm/mmu.c | 6 +-
virt/kvm/arm/pmu.c | 37 +-
virt/kvm/arm/vgic/vgic-init.c | 11 -
virt/kvm/arm/vgic/vgic-v2.c | 61 +++-
virt/kvm/arm/vgic/vgic-v3.c | 12 +-
virt/kvm/arm/vgic/vgic.c | 21 ++
virt/kvm/arm/vgic/vgic.h | 3 +
41 files changed, 1229 insertions(+), 701 deletions(-)
rename {virt/kvm/arm => arch/arm64/kvm}/hyp/vgic-v2-sr.c (50%)
--
2.14.2
_______________________________________________
kvmarm mailing list
kvmarm@xxxxxxxxxxxxxxxxxxxxx
https://lists.cs.columbia.edu/mailman/listinfo/kvmarm
