TDX guests run with MCA enabled (CR4.MCE=1b) from the very start. If that bit is cleared during CR4 register reprogramming during boot or kexec flows, a #VE exception will be raised which the guest kernel cannot handle it. Therefore, make sure the CR4.MCE setting is preserved over kexec too and avoid raising any #VEs. The change doesn't affect non-TDX-guest environments. Signed-off-by: Kirill A. Shutemov <kirill.shutemov@xxxxxxxxxxxxxxx> --- arch/x86/kernel/relocate_kernel_64.S | 17 ++++++++++------- 1 file changed, 10 insertions(+), 7 deletions(-) diff --git a/arch/x86/kernel/relocate_kernel_64.S b/arch/x86/kernel/relocate_kernel_64.S index 085eef5c3904..9c2cf70c5f54 100644 --- a/arch/x86/kernel/relocate_kernel_64.S +++ b/arch/x86/kernel/relocate_kernel_64.S @@ -5,6 +5,8 @@ */ #include <linux/linkage.h> +#include <linux/stringify.h> +#include <asm/alternative.h> #include <asm/page_types.h> #include <asm/kexec.h> #include <asm/processor-flags.h> @@ -145,14 +147,15 @@ SYM_CODE_START_LOCAL_NOALIGN(identity_mapped) * Set cr4 to a known state: * - physical address extension enabled * - 5-level paging, if it was enabled before + * - Machine check exception on TDX guest, if it was enabled before. + * Clearing MCE might not be allowed in TDX guests, depending on setup. + * + * Use R13 that contains the original CR4 value, read in relocate_kernel(). + * PAE is always set in the original CR4. */ - movl $X86_CR4_PAE, %eax - testq $X86_CR4_LA57, %r13 - jz .Lno_la57 - orl $X86_CR4_LA57, %eax -.Lno_la57: - - movq %rax, %cr4 + andl $(X86_CR4_PAE | X86_CR4_LA57), %r13d + ALTERNATIVE "", __stringify(orl $X86_CR4_MCE, %r13d), X86_FEATURE_TDX_GUEST + movq %r13, %cr4 jmp 1f 1: -- Kiryl Shutsemau / Kirill A. Shutemov _______________________________________________ kexec mailing list kexec@xxxxxxxxxxxxxxxxxxx http://lists.infradead.org/mailman/listinfo/kexec