Re: [PATCH 5/5] arm64: kdump: Don't defer the reservation of crash high memory

[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

 



Hi,

On 06/13/22 at 04:09pm, Zhen Lei wrote:
> If the crashkernel has both high memory above DMA zones and low memory
> in DMA zones, kexec always loads the content such as Image and dtb to the
> high memory instead of the low memory. This means that only high memory
> requires write protection based on page-level mapping. The allocation of
> high memory does not depend on the DMA boundary. So we can reserve the
> high memory first even if the crashkernel reservation is deferred.
> 
> This means that the block mapping can still be performed on other kernel
> linear address spaces, the TLB miss rate can be reduced and the system
> performance will be improved.

Ugh, this looks a little ugly, honestly.

If that's for sure arm64 can't split large page mapping of linear
region, this patch is one way to optimize linear mapping. Given kdump
setting is necessary on arm64 server, the booting speed is truly
impacted heavily.

However, I would suggest letting it as is with below reasons:

1) The code will complicate the crashkernel reservatoin code which
is already difficult to understand. 
2) It can only optimize the two cases, first is CONFIG_ZONE_DMA|DMA32
  disabled, the other is crashkernel=,high is specified. While both
  two cases are corner case, most of systems have CONFIG_ZONE_DMA|DMA32
  enabled, and most of systems have crashkernel=xM which is enough.
  Having them optimized won't bring benefit to most of systems.
3) Besides, the crashkernel=,high can be handled earlier because 
  arm64 alwasys have memblock.bottom_up == false currently, thus we
  don't need worry arbout the lower limit of crashkernel,high
  reservation for now. If memblock.bottom_up is set true in the future,
  this patch doesn't work any more.


...
        crash_base = memblock_phys_alloc_range(crash_size, CRASH_ALIGN,
                                               crash_base, crash_max);

So, in my opinion, we can leave the current NON_BLOCK|SECT mapping as
is caused by crashkernel reserving, since no regression is brought.
And meantime, turning to check if there's any way to make the contiguous
linear mapping and later splitting work. The patch 4, 5 in this patchset
doesn't make much sense to me, frankly speaking.

Thanks
Baoquan

> 
> Signed-off-by: Zhen Lei <thunder.leizhen@xxxxxxxxxx>
> ---
>  arch/arm64/mm/init.c | 71 ++++++++++++++++++++++++++++++++++++++++----
>  1 file changed, 65 insertions(+), 6 deletions(-)
> 
> diff --git a/arch/arm64/mm/init.c b/arch/arm64/mm/init.c
> index fb24efbc46f5ef4..ae0bae2cafe6ab0 100644
> --- a/arch/arm64/mm/init.c
> +++ b/arch/arm64/mm/init.c
> @@ -141,15 +141,44 @@ static void __init reserve_crashkernel(int dma_state)
>  	unsigned long long crash_max = CRASH_ADDR_LOW_MAX;
>  	char *cmdline = boot_command_line;
>  	int dma_enabled = IS_ENABLED(CONFIG_ZONE_DMA) || IS_ENABLED(CONFIG_ZONE_DMA32);
> -	int ret;
> +	int ret, skip_res = 0, skip_low_res = 0;
>  	bool fixed_base;
>  
>  	if (!IS_ENABLED(CONFIG_KEXEC_CORE))
>  		return;
>  
> -	if ((!dma_enabled && (dma_state != DMA_PHYS_LIMIT_UNKNOWN)) ||
> -	     (dma_enabled && (dma_state != DMA_PHYS_LIMIT_KNOWN)))
> -		return;
> +	/*
> +	 * In the following table:
> +	 * X,high  means crashkernel=X,high
> +	 * unknown means dma_state = DMA_PHYS_LIMIT_UNKNOWN
> +	 * known   means dma_state = DMA_PHYS_LIMIT_KNOWN
> +	 *
> +	 * The first two columns indicate the status, and the last two
> +	 * columns indicate the phase in which crash high or low memory
> +	 * needs to be reserved.
> +	 *  ---------------------------------------------------
> +	 * | DMA enabled | X,high used |  unknown  |   known   |
> +	 *  ---------------------------------------------------
> +	 * |      N            N       |    low    |    NOP    |
> +	 * |      Y            N       |    NOP    |    low    |
> +	 * |      N            Y       |  high/low |    NOP    |
> +	 * |      Y            Y       |    high   |    low    |
> +	 *  ---------------------------------------------------
> +	 *
> +	 * But in this function, the crash high memory allocation of
> +	 * crashkernel=Y,high and the crash low memory allocation of
> +	 * crashkernel=X[@offset] for crashk_res are mixed at one place.
> +	 * So the table above need to be adjusted as below:
> +	 *  ---------------------------------------------------
> +	 * | DMA enabled | X,high used |  unknown  |   known   |
> +	 *  ---------------------------------------------------
> +	 * |      N            N       |    res    |    NOP    |
> +	 * |      Y            N       |    NOP    |    res    |
> +	 * |      N            Y       |res/low_res|    NOP    |
> +	 * |      Y            Y       |    res    |  low_res  |
> +	 *  ---------------------------------------------------
> +	 *
> +	 */
>  
>  	/* crashkernel=X[@offset] */
>  	ret = parse_crashkernel(cmdline, memblock_phys_mem_size(),
> @@ -169,10 +198,33 @@ static void __init reserve_crashkernel(int dma_state)
>  		else if (ret)
>  			return;
>  
> +		/* See the third row of the second table above, NOP */
> +		if (!dma_enabled && (dma_state == DMA_PHYS_LIMIT_KNOWN))
> +			return;
> +
> +		/* See the fourth row of the second table above */
> +		if (dma_enabled) {
> +			if (dma_state == DMA_PHYS_LIMIT_UNKNOWN)
> +				skip_low_res = 1;
> +			else
> +				skip_res = 1;
> +		}
> +
>  		crash_max = CRASH_ADDR_HIGH_MAX;
>  	} else if (ret || !crash_size) {
>  		/* The specified value is invalid */
>  		return;
> +	} else {
> +		/* See the 1-2 rows of the second table above, NOP */
> +		if ((!dma_enabled && (dma_state == DMA_PHYS_LIMIT_KNOWN)) ||
> +		     (dma_enabled && (dma_state == DMA_PHYS_LIMIT_UNKNOWN)))
> +			return;
> +	}
> +
> +	if (skip_res) {
> +		crash_base = crashk_res.start;
> +		crash_size = crashk_res.end - crashk_res.start + 1;
> +		goto check_low;
>  	}
>  
>  	fixed_base = !!crash_base;
> @@ -202,9 +254,18 @@ static void __init reserve_crashkernel(int dma_state)
>  		return;
>  	}
>  
> +	crashk_res.start = crash_base;
> +	crashk_res.end = crash_base + crash_size - 1;
> +
> +check_low:
> +	if (skip_low_res)
> +		return;
> +
>  	if ((crash_base >= CRASH_ADDR_LOW_MAX) &&
>  	     crash_low_size && reserve_crashkernel_low(crash_low_size)) {
>  		memblock_phys_free(crash_base, crash_size);
> +		crashk_res.start = 0;
> +		crashk_res.end = 0;
>  		return;
>  	}
>  
> @@ -219,8 +280,6 @@ static void __init reserve_crashkernel(int dma_state)
>  	if (crashk_low_res.end)
>  		kmemleak_ignore_phys(crashk_low_res.start);
>  
> -	crashk_res.start = crash_base;
> -	crashk_res.end = crash_base + crash_size - 1;
>  	insert_resource(&iomem_resource, &crashk_res);
>  }
>  
> -- 
> 2.25.1
> 


_______________________________________________
kexec mailing list
kexec@xxxxxxxxxxxxxxxxxxx
http://lists.infradead.org/mailman/listinfo/kexec



[Index of Archives]     [LM Sensors]     [Linux Sound]     [ALSA Users]     [ALSA Devel]     [Linux Audio Users]     [Linux Media]     [Kernel]     [Gimp]     [Yosemite News]     [Linux Media]

  Powered by Linux