On Fri, 20 Dec, at 06:02:10PM, Dave Young wrote: > Here is the V7 patchset for supporting kexec kernel efi runtime. > Per pervious discussion I pass the 1st kernel efi runtime mapping > via setup_data to 2nd kernel. Besides of the runtime mapping > info I also pass the fw_vendor, runtime, config table, smbios > physical address in setup_data. EFI spec mentioned fw_vendor, > runtime, config table addresses will be converted to virt address > after entering virtual mode, but we will use it as physical address > in efi_init. For smbios EFI spec did not mention about the address > updating, but during my test on a HP workstation, the bios will > convert it to Virt addr, thus pass it in setup_data as well. OK Dave, I've pulled patches 3-12 into the 'kexec' branch at, git://git.kernel.org/pub/scm/linux/kernel/git/mfleming/efi.git I plan on sending this branch to the tip folks this week for further testing. Please have a look and make sure I haven't messed anything up when dropping the first two patches (though they were very small and trival). Toshi, if you could grab that branch and give it a test, that'd be excellent. -- Matt Fleming, Intel Open Source Technology Center