Since commit 30d9aa4265fe ("drm/i915: Read sink_count dpcd always"),
the status of a DP connector depends on its sink count value.
However, some eDP panels don't set that value appropriately,
causing them to be reported as disconnected.
Fix this by ignoring sink count for eDP.
Fixes: 30d9aa4265fe ("drm/i915: Read sink_count dpcd always")
Cc: Ander Conselvan De Oliveira <conselvan2@xxxxxxxxx>
Cc: Jani Nikula <jani.nikula@xxxxxxxxxxxxxxx>
Reported-by: Tvrtko Ursulin <tvrtko.ursulin@xxxxxxxxxxxxxxx>
Signed-off-by: Sivakumar Thulasimani <sivakumar.thulasimani@xxxxxxxxx>
Signed-off-by: Shubhangi Shrivastava <shubhangi.shrivastava@xxxxxxxxx>
---
drivers/gpu/drm/i915/intel_dp.c | 5 ++++-
1 file changed, 4 insertions(+), 1 deletion(-)
diff --git a/drivers/gpu/drm/i915/intel_dp.c b/drivers/gpu/drm/i915/intel_dp.c
index da0c3d2..bdc7e12 100644
--- a/drivers/gpu/drm/i915/intel_dp.c
+++ b/drivers/gpu/drm/i915/intel_dp.c
@@ -3806,7 +3806,7 @@ intel_dp_get_dpcd(struct intel_dp *intel_dp)
* downstream port information. So, an early return here saves
* time from performing other operations which are not required.
*/
- if (!intel_dp->sink_count)
+ if (!is_edp(intel_dp) && !intel_dp->sink_count)
return false;
/* Check if the panel supports PSR */
@@ -4339,6 +4339,9 @@ intel_dp_detect_dpcd(struct intel_dp *intel_dp)
if (!intel_dp_get_dpcd(intel_dp))
return connector_status_disconnected;
+ if (is_edp(intel_dp))
+ return connector_status_connected;
+
/* if there's no downstream port, we're done */
if (!(dpcd[DP_DOWNSTREAMPORT_PRESENT] & DP_DWN_STRM_PORT_PRESENT))
return connector_status_connected;
--
2.6.1
_______________________________________________
Intel-gfx mailing list
Intel-gfx@xxxxxxxxxxxxxxxxxxxxx
https://lists.freedesktop.org/mailman/listinfo/intel-gfx
