We accidentally point both cfgcr registers for the second shared DPLL to
the same location in i915_reg.h. This results in a lot of hw pipe state
mismatches whenever we try to do a modeset that requires allocating the
DPLL to a CRTC:
[drm:intel_pipe_config_compare [i915]] *ERROR* mismatch in dpll_hw_state.cfgcr1 (expected 0x80000168, found 0x000004a5)
[drm:intel_pipe_config_compare [i915]] *ERROR* mismatch in base.adjusted_mode.crtc_clock (expected 108000, found 49500)
[drm:intel_pipe_config_compare [i915]] *ERROR* mismatch in port_clock (expected 108000, found 49500)
This usually ends up causing blank monitors, since the DPLL never can
get set to the right clock.
Fixes: f0f59a00a1 ("drm/i915: Type safe register read/write")
Signed-off-by: Lyude <cpaul@xxxxxxxxxx>
---
drivers/gpu/drm/i915/i915_reg.h | 2 +-
1 file changed, 1 insertion(+), 1 deletion(-)
diff --git a/drivers/gpu/drm/i915/i915_reg.h b/drivers/gpu/drm/i915/i915_reg.h
index 007ae83..b9a564b 100644
--- a/drivers/gpu/drm/i915/i915_reg.h
+++ b/drivers/gpu/drm/i915/i915_reg.h
@@ -7514,7 +7514,7 @@ enum skl_disp_power_wells {
#define DPLL_CFGCR2_PDIV_7 (4<<2)
#define DPLL_CFGCR2_CENTRAL_FREQ_MASK (3)
-#define DPLL_CFGCR1(id) _MMIO_PIPE((id) - SKL_DPLL1, _DPLL1_CFGCR1, _DPLL2_CFGCR2)
+#define DPLL_CFGCR1(id) _MMIO_PIPE((id) - SKL_DPLL1, _DPLL1_CFGCR1, _DPLL2_CFGCR1)
#define DPLL_CFGCR2(id) _MMIO_PIPE((id) - SKL_DPLL1, _DPLL1_CFGCR2, _DPLL2_CFGCR2)
/* BXT display engine PLL */
--
2.5.0
_______________________________________________
Intel-gfx mailing list
Intel-gfx@xxxxxxxxxxxxxxxxxxxxx
http://lists.freedesktop.org/mailman/listinfo/intel-gfx
