On Tue, Oct 13, 2015 at 04:00:37PM +0200, Maarten Lankhorst wrote: > Op 13-10-15 om 15:58 schreef Daniel Vetter: > > On Tue, Oct 13, 2015 at 03:43:28PM +0200, Maarten Lankhorst wrote: > >> Op 13-10-15 om 15:35 schreef Daniel Vetter: > >>> On Tue, Oct 13, 2015 at 03:18:16PM +0200, Maarten Lankhorst wrote: > >>>> Op 23-09-15 om 17:34 schreef Gabriel Feceoru: > >>>>> Using 2 connectors (DVI and VGA) will cause wrpll to be set for > >>>>> INTEL_OUTPUT_HDMI but never reset if switching to INTEL_OUTPUT_VGA > >>>>> > >>>>> Supresses errors like these: > >>>>> [drm:intel_pipe_config_compare [i915]] *ERROR* mismatch in dpll_hw_state.wrpll > >>>>> > >>>> Looks like a good idea to always zero it. > >>> Except that we still have a bunch of cases where we recompute clock state > >>> but only partially. Can we just move them all up into a common place > >>> please? That would also catch cases where we simply forget to fill this > >>> out at all. > >>> > >>> One case I noticed is edp in skl_ddi_pll_select, but there's probably > >>> more. > >>> > >> Something like below, with all the memsets for dpll_hw_state removed? > > I think this will blow up since we recompute clock state only when > > needs_modeset is true. So needs a bit more intelligence in deciding when > > to clear it I think. > Oops you're right. Maybe intel_modeset_clear_plls because that's where all the clock state belongs? Yeah that might be an even better place, in the loop after the continue; statement. -Daniel -- Daniel Vetter Software Engineer, Intel Corporation http://blog.ffwll.ch _______________________________________________ Intel-gfx mailing list Intel-gfx@xxxxxxxxxxxxxxxxxxxxx http://lists.freedesktop.org/mailman/listinfo/intel-gfx
