On Thu, Jul 23, 2015 at 9:38 AM, Lee Jones <lee.jones@xxxxxxxxxx> wrote: > On Wed, 22 Jul 2015, Daniel Vetter wrote: >> On Wed, Jul 22, 2015 at 02:01:44PM +0530, Shobhit Kumar wrote: >> > This is needed as the CRC PMIC has support for Panel >> > enable/diable as gpio which needs 'gpiod_add_lookup_table' >> > and 'gpiod_remove_lookup_table' from gpiolib. This patch >> > can be squashed with below commit in topic/crc-pmic branch >> > >> > commit 61dd2ca2d44e493b050adbbb75bc50db11c367dd >> > Author: Shobhit Kumar <shobhit.kumar@xxxxxxxxx> >> > Date: Fri Jun 26 14:32:05 2015 +0530 >> > >> > mfd: intel_soc_pmic_core: Add lookup table for Panel Control as GPIO >> > signal >> > >> > On some Intel SoC platforms, the panel enable/disable signals >> > are controlled by CRC PMIC. Add those control as a new GPIO in a >> > lookup table for gpio-crystalcove chip during CRC driver load >> > >> > Cc: Lee Jones <lee.jones@xxxxxxxxxx> >> > Cc: Linus Walleij <linus.walleij@xxxxxxxxxx> >> > Signed-off-by: Shobhit Kumar <shobhit.kumar@xxxxxxxxx> >> >> Applied, thanks. > > You can't just apply changes made to other subsystems willy-nilly. > > You should wait for an Ack, despite the triviality of the patch, even > if it's just out of courtesy. Sorry about that, figured getting rid of the compile fail asap is better. Should I revert it again and update the pull request? -Daniel -- Daniel Vetter Software Engineer, Intel Corporation +41 (0) 79 365 57 48 - http://blog.ffwll.ch _______________________________________________ Intel-gfx mailing list Intel-gfx@xxxxxxxxxxxxxxxxxxxxx http://lists.freedesktop.org/mailman/listinfo/intel-gfx
