Re: [PATCH 27/42] drm/i915: Remove use of crtc->config from intel_dp.c

[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

 



Op 12-05-15 om 11:22 schreef Daniel Vetter:
> On Mon, May 11, 2015 at 04:25:03PM +0200, Maarten Lankhorst wrote:
>> Signed-off-by: Maarten Lankhorst <maarten.lankhorst@xxxxxxxxxxxxxxx>
>> ---
>>  drivers/gpu/drm/i915/intel_dp.c | 33 ++++++++++++++++++---------------
>>  1 file changed, 18 insertions(+), 15 deletions(-)
>>
>> diff --git a/drivers/gpu/drm/i915/intel_dp.c b/drivers/gpu/drm/i915/intel_dp.c
>> index eda1b22c3111..e6876faca7f0 100644
>> --- a/drivers/gpu/drm/i915/intel_dp.c
>> +++ b/drivers/gpu/drm/i915/intel_dp.c
>> @@ -1536,7 +1536,9 @@ static void intel_dp_prepare(struct intel_encoder *encoder)
>>  	struct intel_dp *intel_dp = enc_to_intel_dp(&encoder->base);
>>  	enum port port = dp_to_dig_port(intel_dp)->port;
>>  	struct intel_crtc *crtc = to_intel_crtc(encoder->base.crtc);
>> -	struct drm_display_mode *adjusted_mode = &crtc->config->base.adjusted_mode;
>> +	struct intel_crtc_state *pipe_config =
>> +		to_intel_crtc_state(crtc->base.state);
>> +	struct drm_display_mode *adjusted_mode = &pipe_config->base.adjusted_mode;
>>  
>>  	/*
>>  	 * There are four kinds of DP registers:
>> @@ -1564,7 +1566,7 @@ static void intel_dp_prepare(struct intel_encoder *encoder)
>>  	intel_dp->DP |= DP_VOLTAGE_0_4 | DP_PRE_EMPHASIS_0;
>>  	intel_dp->DP |= DP_PORT_WIDTH(intel_dp->lane_count);
>>  
>> -	if (crtc->config->has_audio)
>> +	if (pipe_config->has_audio)
>>  		intel_dp->DP |= DP_AUDIO_OUTPUT_ENABLE;
>>  
>>  	/* Split out the IBX/CPU vs CPT settings */
>> @@ -2504,6 +2506,8 @@ static void intel_enable_dp(struct intel_encoder *encoder)
>>  	struct drm_device *dev = encoder->base.dev;
>>  	struct drm_i915_private *dev_priv = dev->dev_private;
>>  	struct intel_crtc *crtc = to_intel_crtc(encoder->base.crtc);
>> +	struct intel_crtc_state *pipe_config =
>> +		to_intel_crtc_state(crtc->base.state);
>>  	uint32_t dp_reg = I915_READ(intel_dp->output_reg);
>>  	unsigned int lane_mask = 0x0;
>>  
>> @@ -2532,7 +2536,7 @@ static void intel_enable_dp(struct intel_encoder *encoder)
>>  	intel_dp_complete_link_train(intel_dp);
>>  	intel_dp_stop_link_train(intel_dp);
>>  
>> -	if (crtc->config->has_audio) {
>> +	if (pipe_config->has_audio) {
>>  		DRM_DEBUG_DRIVER("Enabling DP audio on pipe %c\n",
>>  				 pipe_name(crtc->pipe));
>>  		intel_audio_codec_enable(encoder);
>> @@ -2741,6 +2745,8 @@ static void chv_pre_enable_dp(struct intel_encoder *encoder)
>>  	struct intel_crtc *intel_crtc =
>>  		to_intel_crtc(encoder->base.crtc);
>>  	enum dpio_channel ch = vlv_dport_to_channel(dport);
>> +	struct intel_crtc_state *pipe_config =
>> +		to_intel_crtc_state(intel_crtc->base.state);
>>  	int pipe = intel_crtc->pipe;
>>  	int data, i, stagger;
>>  	u32 val;
>> @@ -2782,13 +2788,13 @@ static void chv_pre_enable_dp(struct intel_encoder *encoder)
>>  	}
>>  
>>  	/* Data lane stagger programming */
>> -	if (intel_crtc->config->port_clock > 270000)
>> +	if (pipe_config->port_clock > 270000)
>>  		stagger = 0x18;
>> -	else if (intel_crtc->config->port_clock > 135000)
>> +	else if (pipe_config->port_clock > 135000)
>>  		stagger = 0xd;
>> -	else if (intel_crtc->config->port_clock > 67500)
>> +	else if (pipe_config->port_clock > 67500)
>>  		stagger = 0x7;
>> -	else if (intel_crtc->config->port_clock > 33750)
>> +	else if (pipe_config->port_clock > 33750)
>>  		stagger = 0x4;
>>  	else
>>  		stagger = 0x2;
>> @@ -4302,7 +4308,7 @@ intel_dp_check_link_status(struct intel_dp *intel_dp)
>>  	if (WARN_ON(!intel_encoder->base.crtc))
>>  		return;
>>  
>> -	if (!to_intel_crtc(intel_encoder->base.crtc)->active)
>> +	if (!intel_encoder->base.crtc->state->active)
>>  		return;
>>  
>>  	/* Try to read receiver status if the link appears to be up */
>> @@ -5255,7 +5261,8 @@ static void intel_dp_set_drrs_state(struct drm_device *dev, int refresh_rate)
>>  	struct intel_encoder *encoder;
>>  	struct intel_digital_port *dig_port = NULL;
>>  	struct intel_dp *intel_dp = dev_priv->drrs.dp;
>> -	struct intel_crtc *intel_crtc = NULL;
>> +	struct intel_crtc *intel_crtc;
>> +	struct intel_crtc_state *pipe_config;
>>  	u32 reg, val;
>>  	enum drrs_refresh_rate_type index = DRRS_HIGH_RR;
>>  
>> @@ -5277,6 +5284,7 @@ static void intel_dp_set_drrs_state(struct drm_device *dev, int refresh_rate)
> set_drrs_state is also called from _disable hooks, which means you need to
> pass the right pipe_config explicitly.
>
Argh, missed that, thanks.
_______________________________________________
Intel-gfx mailing list
Intel-gfx@xxxxxxxxxxxxxxxxxxxxx
http://lists.freedesktop.org/mailman/listinfo/intel-gfx





[Index of Archives]     [Linux USB Devel]     [Linux Audio Users]     [Yosemite News]     [Linux Kernel]     [Linux SCSI]
  Powered by Linux