On Tue, Aug 05, 2014 at 07:51:23AM -0700, Rodrigo Vivi wrote:
> From: Vandana Kannan <vandana.kannan@xxxxxxxxx>
>
> Adding relevant read out comparison code, in check_crtc_state, for the new
> member of crtc_config, dp_m2_n2, which was introduced to store link_m_n
> values for a DP downclock mode (if available). Suggested by Daniel.
>
> v2: Changed patch title.
> Daniel's review comments incorporated.
> Added relevant state readout code for M2_N2. dp_m2_n2 comparison to be done
> only when high RR is not in use (This is because alternate m_n register
> programming will be done only when low RR is being used).
>
> v3: Modified call to get_m2_n2 which had dp_m_n as param by mistake.
> Compare dp_m_n and dp_m2_n2 for gen 7 and below. compare the structures
> based on DRRS state for gen 8 and above.
> Save and restore M2 N2 registers for gen 7 and below
>
> v4: For Gen>=8, check M_N registers against dp_m_n and dp_m2_n2 as there is
> only one set of M_N registers
>
> v5: Removed the chunk which saves and restores M2_N2 registers. Modified
> get_m_n() to get M2_N2 registers as well. Modified the macro which compares
> hw.dp_m_n against sw.dp_m2_n2/sw.dp_m_n for gen > 8.
>
> v6: Added check to compare dp_m2_n2 only when DRRS is enabled
>
> v7: Modified drrs check to use has_drrs
>
> v8: Add has_drrs check before reading M2_N2 registers
>
> Signed-off-by: Vandana Kannan <vandana.kannan@xxxxxxxxx>
> Cc: Daniel Vetter <daniel.vetter@xxxxxxxx>
> Cc: Jani Nikula <jani.nikula@xxxxxxxxxxxxxxx>
> Cc: Jesse Barnes <jbarnes@xxxxxxxxxxxxxxxx>
> Signed-off-by: Rodrigo Vivi <rodrigo.vivi@xxxxxxxxx>
Both drrs patches pulled in, thanks.
-Daniel
> ---
> drivers/gpu/drm/i915/intel_display.c | 75 ++++++++++++++++++++++++++++++++----
> 1 file changed, 67 insertions(+), 8 deletions(-)
>
> diff --git a/drivers/gpu/drm/i915/intel_display.c b/drivers/gpu/drm/i915/intel_display.c
> index e798acd..b758826 100644
> --- a/drivers/gpu/drm/i915/intel_display.c
> +++ b/drivers/gpu/drm/i915/intel_display.c
> @@ -7145,7 +7145,8 @@ static void intel_pch_transcoder_get_m_n(struct intel_crtc *crtc,
>
> static void intel_cpu_transcoder_get_m_n(struct intel_crtc *crtc,
> enum transcoder transcoder,
> - struct intel_link_m_n *m_n)
> + struct intel_link_m_n *m_n,
> + struct intel_link_m_n *m2_n2)
> {
> struct drm_device *dev = crtc->base.dev;
> struct drm_i915_private *dev_priv = dev->dev_private;
> @@ -7159,6 +7160,20 @@ static void intel_cpu_transcoder_get_m_n(struct intel_crtc *crtc,
> m_n->gmch_n = I915_READ(PIPE_DATA_N1(transcoder));
> m_n->tu = ((I915_READ(PIPE_DATA_M1(transcoder))
> & TU_SIZE_MASK) >> TU_SIZE_SHIFT) + 1;
> + /* Read M2_N2 registers only for gen < 8 (M2_N2 available for
> + * gen < 8) and if DRRS is supported (to make sure the
> + * registers are not unnecessarily read).
> + */
> + if (m2_n2 && INTEL_INFO(dev)->gen < 8 &&
> + crtc->config.has_drrs) {
> + m2_n2->link_m = I915_READ(PIPE_LINK_M2(transcoder));
> + m2_n2->link_n = I915_READ(PIPE_LINK_N2(transcoder));
> + m2_n2->gmch_m = I915_READ(PIPE_DATA_M2(transcoder))
> + & ~TU_SIZE_MASK;
> + m2_n2->gmch_n = I915_READ(PIPE_DATA_N2(transcoder));
> + m2_n2->tu = ((I915_READ(PIPE_DATA_M2(transcoder))
> + & TU_SIZE_MASK) >> TU_SIZE_SHIFT) + 1;
> + }
> } else {
> m_n->link_m = I915_READ(PIPE_LINK_M_G4X(pipe));
> m_n->link_n = I915_READ(PIPE_LINK_N_G4X(pipe));
> @@ -7177,14 +7192,15 @@ void intel_dp_get_m_n(struct intel_crtc *crtc,
> intel_pch_transcoder_get_m_n(crtc, &pipe_config->dp_m_n);
> else
> intel_cpu_transcoder_get_m_n(crtc, pipe_config->cpu_transcoder,
> - &pipe_config->dp_m_n);
> + &pipe_config->dp_m_n,
> + &pipe_config->dp_m2_n2);
> }
>
> static void ironlake_get_fdi_m_n_config(struct intel_crtc *crtc,
> struct intel_crtc_config *pipe_config)
> {
> intel_cpu_transcoder_get_m_n(crtc, pipe_config->cpu_transcoder,
> - &pipe_config->fdi_m_n);
> + &pipe_config->fdi_m_n, NULL);
> }
>
> static void ironlake_get_pfit_config(struct intel_crtc *crtc,
> @@ -10001,6 +10017,15 @@ static void intel_dump_pipe_config(struct intel_crtc *crtc,
> pipe_config->dp_m_n.gmch_m, pipe_config->dp_m_n.gmch_n,
> pipe_config->dp_m_n.link_m, pipe_config->dp_m_n.link_n,
> pipe_config->dp_m_n.tu);
> +
> + DRM_DEBUG_KMS("dp: %i, gmch_m2: %u, gmch_n2: %u, link_m2: %u, link_n2: %u, tu2: %u\n",
> + pipe_config->has_dp_encoder,
> + pipe_config->dp_m2_n2.gmch_m,
> + pipe_config->dp_m2_n2.gmch_n,
> + pipe_config->dp_m2_n2.link_m,
> + pipe_config->dp_m2_n2.link_n,
> + pipe_config->dp_m2_n2.tu);
> +
> DRM_DEBUG_KMS("requested mode:\n");
> drm_mode_debug_printmodeline(&pipe_config->requested_mode);
> DRM_DEBUG_KMS("adjusted mode:\n");
> @@ -10381,6 +10406,22 @@ intel_pipe_config_compare(struct drm_device *dev,
> return false; \
> }
>
> +/* This is required for BDW+ where there is only one set of registers for
> + * switching between high and low RR.
> + * This macro can be used whenever a comparison has to be made between one
> + * hw state and multiple sw state variables.
> + */
> +#define PIPE_CONF_CHECK_I_ALT(name, alt_name) \
> + if ((current_config->name != pipe_config->name) && \
> + (current_config->alt_name != pipe_config->name)) { \
> + DRM_ERROR("mismatch in " #name " " \
> + "(expected %i or %i, found %i)\n", \
> + current_config->name, \
> + current_config->alt_name, \
> + pipe_config->name); \
> + return false; \
> + }
> +
> #define PIPE_CONF_CHECK_FLAGS(name, mask) \
> if ((current_config->name ^ pipe_config->name) & (mask)) { \
> DRM_ERROR("mismatch in " #name "(" #mask ") " \
> @@ -10413,11 +10454,28 @@ intel_pipe_config_compare(struct drm_device *dev,
> PIPE_CONF_CHECK_I(fdi_m_n.tu);
>
> PIPE_CONF_CHECK_I(has_dp_encoder);
> - PIPE_CONF_CHECK_I(dp_m_n.gmch_m);
> - PIPE_CONF_CHECK_I(dp_m_n.gmch_n);
> - PIPE_CONF_CHECK_I(dp_m_n.link_m);
> - PIPE_CONF_CHECK_I(dp_m_n.link_n);
> - PIPE_CONF_CHECK_I(dp_m_n.tu);
> +
> + if (INTEL_INFO(dev)->gen < 8) {
> + PIPE_CONF_CHECK_I(dp_m_n.gmch_m);
> + PIPE_CONF_CHECK_I(dp_m_n.gmch_n);
> + PIPE_CONF_CHECK_I(dp_m_n.link_m);
> + PIPE_CONF_CHECK_I(dp_m_n.link_n);
> + PIPE_CONF_CHECK_I(dp_m_n.tu);
> +
> + if (current_config->has_drrs) {
> + PIPE_CONF_CHECK_I(dp_m2_n2.gmch_m);
> + PIPE_CONF_CHECK_I(dp_m2_n2.gmch_n);
> + PIPE_CONF_CHECK_I(dp_m2_n2.link_m);
> + PIPE_CONF_CHECK_I(dp_m2_n2.link_n);
> + PIPE_CONF_CHECK_I(dp_m2_n2.tu);
> + }
> + } else {
> + PIPE_CONF_CHECK_I_ALT(dp_m_n.gmch_m, dp_m2_n2.gmch_m);
> + PIPE_CONF_CHECK_I_ALT(dp_m_n.gmch_n, dp_m2_n2.gmch_n);
> + PIPE_CONF_CHECK_I_ALT(dp_m_n.link_m, dp_m2_n2.link_m);
> + PIPE_CONF_CHECK_I_ALT(dp_m_n.link_n, dp_m2_n2.link_n);
> + PIPE_CONF_CHECK_I_ALT(dp_m_n.tu, dp_m2_n2.tu);
> + }
>
> PIPE_CONF_CHECK_I(adjusted_mode.crtc_hdisplay);
> PIPE_CONF_CHECK_I(adjusted_mode.crtc_htotal);
> @@ -10503,6 +10561,7 @@ intel_pipe_config_compare(struct drm_device *dev,
>
> #undef PIPE_CONF_CHECK_X
> #undef PIPE_CONF_CHECK_I
> +#undef PIPE_CONF_CHECK_I_ALT
> #undef PIPE_CONF_CHECK_FLAGS
> #undef PIPE_CONF_CHECK_CLOCK_FUZZY
> #undef PIPE_CONF_QUIRK
> --
> 1.9.3
>
--
Daniel Vetter
Software Engineer, Intel Corporation
+41 (0) 79 365 57 48 - http://blog.ffwll.ch
_______________________________________________
Intel-gfx mailing list
Intel-gfx@xxxxxxxxxxxxxxxxxxxxx
http://lists.freedesktop.org/mailman/listinfo/intel-gfx
