On Mon, Apr 14, 2014 at 08:24:30PM +0300, Imre Deak wrote: > Atm we can end up in the GPU reset deferred work in D3 state if the last > runtime PM reference is dropped between detecting a hang/scheduling the > work and executing the work. At least one such case I could trigger is > the simulated reset via the i915_wedged debugfs entry. Fix this by > disabling RPM before scheduling the work until the end of the work. > > v2: > - Instead of getting/putting the RPM reference in the reset work itself, > get it already before scheduling the work. By this we also prevent > going to D3 before the work gets to run, in addition to making sure > that we run the work itself in D0. (Ville, Daniel) > > Signed-off-by: Imre Deak <imre.deak@xxxxxxxxx> > --- > drivers/gpu/drm/i915/i915_dma.c | 8 +++++++- > drivers/gpu/drm/i915/i915_irq.c | 21 ++++++++++++++++++++- > 2 files changed, 27 insertions(+), 2 deletions(-) > > diff --git a/drivers/gpu/drm/i915/i915_dma.c b/drivers/gpu/drm/i915/i915_dma.c > index 0b38f88..6398280 100644 > --- a/drivers/gpu/drm/i915/i915_dma.c > +++ b/drivers/gpu/drm/i915/i915_dma.c > @@ -1823,7 +1823,13 @@ int i915_driver_unload(struct drm_device *dev) > > /* Free error state after interrupts are fully disabled. */ > del_timer_sync(&dev_priv->gpu_error.hangcheck_timer); > - cancel_work_sync(&dev_priv->gpu_error.work); > + if (!cancel_work_sync(&dev_priv->gpu_error.work)) '!' shouldn't be there > + /* > + * The following won't make any difference in the PM state, > + * since RPM is disabled already, but do it still for > + * consistency. > + */ > + intel_runtime_pm_put(dev_priv); > i915_destroy_error_state(dev); > > if (dev->pdev->msi_enabled) > diff --git a/drivers/gpu/drm/i915/i915_irq.c b/drivers/gpu/drm/i915/i915_irq.c > index a651d0d..5e079d8 100644 > --- a/drivers/gpu/drm/i915/i915_irq.c > +++ b/drivers/gpu/drm/i915/i915_irq.c > @@ -2210,6 +2210,9 @@ static void i915_error_work_func(struct work_struct *work) > */ > i915_error_wake_up(dev_priv, true); > } > + > + /* Drop the ref we took when scheduling this work. */ > + intel_runtime_pm_put(dev_priv); > } > > static void i915_report_and_clear_eir(struct drm_device *dev) > @@ -2353,8 +2356,24 @@ void i915_handle_error(struct drm_device *dev, bool wedged, > * state of outstanding pagelips). Hence it must not be run on our own > * dev-priv->wq work queue for otherwise the flush_work in the pageflip > * code will deadlock. > + * > + * It's guaranteed that here we are in D0 state, since we can only get > + * here via one of the following paths: > + * - From an IRQ handler's error detection. -> The driver must make > + * sure that IRQs are unmasked only while holding an RPM ref. > + * - From hang-check due to a blocked request. -> The request holds an > + * RPM ref, that's only released in i915_gpu_idle() which in turn > + * won't be called until the request is finished. > + * - From hang-check due to a flip hang. -> We have an RPM ref because > + * of the active modeset. > + * - From debugfs i915_wedged_set(). -> The caller takes an explicit > + * RPM ref. > + * Take here an atomic RPM ref still to make sure that we don't > + * re-enter D3 until the error work gets to run and completes the > + * reset. > */ > - schedule_work(&dev_priv->gpu_error.work); > + if (schedule_work(&dev_priv->gpu_error.work)) > + intel_runtime_pm_get_noresume(dev_priv); > } > > static void __always_unused i915_pageflip_stall_check(struct drm_device *dev, int pipe) > -- > 1.8.4 > > _______________________________________________ > Intel-gfx mailing list > Intel-gfx@xxxxxxxxxxxxxxxxxxxxx > http://lists.freedesktop.org/mailman/listinfo/intel-gfx -- Ville Syrjälä Intel OTC _______________________________________________ Intel-gfx mailing list Intel-gfx@xxxxxxxxxxxxxxxxxxxxx http://lists.freedesktop.org/mailman/listinfo/intel-gfx
