Daniel Vetter writes:
> On Mon, Apr 14, 2014 at 07:26:09PM +0200, Egbert Eich wrote:
> > Depending on the SDVO output_flags SDVO may have multiple connectors.
> > These are all initialized in intel_sdvo_output_setup(). The connector
> > that is initialized later will override the encoder_type that has been
> > set up by an earlier connector type initialization. Eventually the
> > one that comes last wins.
> > Eventually when intel_sdvo_detect() is called the active connector is
> > determined.
> > Delay encoder type initialization until the active connector is known
> > and set it to the type that corresponds to this connector.
> >
> > Signed-off-by: Egbert Eich <eich@xxxxxxx>
>
> Hm, has this any effect on the code itself? I think if we want to fix this
> just for optics we should add a new DRM_MODE_ENCODER_MULTI. At least I
> have an sdvo here which has a dac, hdmi and tv-out ...
With the present logic the last connector in the list matching a flag bit
will win the encoder type. The encoder type is presently just used for
(debug) messages, so it is cosmetic.
>
> This also reminds that I should finally polish of the multi-sdvo fixes I
> have around here - currently the last encoder detected wins on a
> multi-encoder chip, which means if you have an lvds+hdmi combo and plug in
> a screeen you'll never be able to use the lvds again until the hdmi is
> unplugged.
You know, from looking at the code I was wondering already if this was
possible at all.
I stayed away tinkering with this - there doesn't seem to be documentation
on the SDVO command set publically available. Moreover I'm moslty dealing
with cash registers here - so I doubt they have all the SVIDEO connectors
they advertise ;) But I can't tell as I don't even have physical access!
As I read the current code it seems like bad things could happen
if more than one bit is set in intel_sdvo->attached_output: after all
tv-out should have quite different timing requirements than a TMDS.
>
> Much worse if there's a tv-out detect issue ;-)
;p
Cheers,
Egbert.
>
> Cheers, Daniel
>
> > ---
> > drivers/gpu/drm/i915/intel_sdvo.c | 23 ++++++++++++++++++-----
> > 1 file changed, 18 insertions(+), 5 deletions(-)
> >
> > diff --git a/drivers/gpu/drm/i915/intel_sdvo.c b/drivers/gpu/drm/i915/intel_sdvo.c
> > index d27155a..5043f16 100644
> > --- a/drivers/gpu/drm/i915/intel_sdvo.c
> > +++ b/drivers/gpu/drm/i915/intel_sdvo.c
> > @@ -154,6 +154,9 @@ struct intel_sdvo_connector {
> > /* Mark the type of connector */
> > uint16_t output_flag;
> >
> > + /* store encoder type for convenience */
> > + int encoder_type;
> > +
> > enum hdmi_force_audio force_audio;
> >
> > /* This contains all current supported TV format */
> > @@ -1746,6 +1749,7 @@ intel_sdvo_detect(struct drm_connector *connector, bool force)
> > if (response == 0)
> > return connector_status_disconnected;
> >
> > + intel_sdvo->base.base.encoder_type = intel_sdvo_connector->encoder_type;
> > intel_sdvo->attached_output = response;
> >
> > intel_sdvo->has_hdmi_monitor = false;
> > @@ -2489,7 +2493,9 @@ intel_sdvo_dvi_init(struct intel_sdvo *intel_sdvo, int device)
> > } else {
> > intel_connector->polled = DRM_CONNECTOR_POLL_CONNECT | DRM_CONNECTOR_POLL_DISCONNECT;
> > }
> > - encoder->encoder_type = DRM_MODE_ENCODER_TMDS;
> > + /* delay encoder_type setting until detection */
> > + intel_sdvo_connector->encoder_type = DRM_MODE_ENCODER_TMDS;
> > + encoder->encoder_type = DRM_MODE_ENCODER_NONE;
> > connector->connector_type = DRM_MODE_CONNECTOR_DVID;
> >
> > if (intel_sdvo_is_hdmi_connector(intel_sdvo, device)) {
> > @@ -2524,7 +2530,9 @@ intel_sdvo_tv_init(struct intel_sdvo *intel_sdvo, int type)
> >
> > intel_connector = &intel_sdvo_connector->base;
> > connector = &intel_connector->base;
> > - encoder->encoder_type = DRM_MODE_ENCODER_TVDAC;
> > + /* delay encoder_type setting until detection */
> > + intel_sdvo_connector->encoder_type = DRM_MODE_ENCODER_TVDAC;
> > + encoder->encoder_type = DRM_MODE_ENCODER_NONE;
> > connector->connector_type = DRM_MODE_CONNECTOR_SVIDEO;
> >
> > intel_sdvo->controlled_output |= type;
> > @@ -2568,7 +2576,9 @@ intel_sdvo_analog_init(struct intel_sdvo *intel_sdvo, int device)
> > intel_connector = &intel_sdvo_connector->base;
> > connector = &intel_connector->base;
> > intel_connector->polled = DRM_CONNECTOR_POLL_CONNECT;
> > - encoder->encoder_type = DRM_MODE_ENCODER_DAC;
> > + /* delay encoder_type setting until detection */
> > + intel_sdvo_connector->encoder_type = DRM_MODE_ENCODER_DAC;
> > + encoder->encoder_type = DRM_MODE_ENCODER_NONE;
> > connector->connector_type = DRM_MODE_CONNECTOR_VGA;
> >
> > if (device == 0) {
> > @@ -2603,7 +2613,9 @@ intel_sdvo_lvds_init(struct intel_sdvo *intel_sdvo, int device)
> >
> > intel_connector = &intel_sdvo_connector->base;
> > connector = &intel_connector->base;
> > - encoder->encoder_type = DRM_MODE_ENCODER_LVDS;
> > + /* delay encoder_type setting until detection */
> > + intel_sdvo_connector->encoder_type = DRM_MODE_ENCODER_LVDS;
> > + encoder->encoder_type = DRM_MODE_ENCODER_NONE;
> > connector->connector_type = DRM_MODE_CONNECTOR_LVDS;
> >
> > if (device == 0) {
> > @@ -2984,7 +2996,8 @@ bool intel_sdvo_init(struct drm_device *dev, uint32_t sdvo_reg, bool is_sdvob)
> > /* encoder type will be decided later */
> > intel_encoder = &intel_sdvo->base;
> > intel_encoder->type = INTEL_OUTPUT_SDVO;
> > - drm_encoder_init(dev, &intel_encoder->base, &intel_sdvo_enc_funcs, 0);
> > + drm_encoder_init(dev, &intel_encoder->base, &intel_sdvo_enc_funcs,
> > + DRM_MODE_ENCODER_NONE);
> >
> > /* Read the regs to test if we can talk to the device */
> > for (i = 0; i < 0x40; i++) {
> > --
> > 1.8.4.5
> >
> > _______________________________________________
> > Intel-gfx mailing list
> > Intel-gfx@xxxxxxxxxxxxxxxxxxxxx
> > http://lists.freedesktop.org/mailman/listinfo/intel-gfx
>
> --
> Daniel Vetter
> Software Engineer, Intel Corporation
> +41 (0) 79 365 57 48 - http://blog.ffwll.ch
--
Egbert Eich (Res. & Dev.) SUSE LINUX Products GmbH
SUSE Labs KMS / DRM / X Window System Development
Tel: +49 911-740 53 0 http://www.suse.de
-----------------------------------------------------------------
SUSE LINUX Products GmbH, GF: Jeff Hawn, Jennifer Guild, Felix Imendörffer, HRB 16746 (AG Nürnberg)
Maxfeldstraße 5
90409 Nürnberg
Germany
_______________________________________________
Intel-gfx mailing list
Intel-gfx@xxxxxxxxxxxxxxxxxxxxx
http://lists.freedesktop.org/mailman/listinfo/intel-gfx
