From: Deepak S <deepak.s@xxxxxxxxx>
Voltage is not getting dropped to Vmin when GFX enters RC6 and running
in/out of turbo frequency. When we enter RC6 and GFX Clocks are off, the
voltage remains higher than Vmin. As GFX does not request lower
frequencies when it is power gated. Ideally the Voltage should be
dropped to Vmin, To fix this we check for Gfx Idle, and set the freq to
RPe.
Signed-off-by: Deepak S <deepak.s@xxxxxxxxx>
---
drivers/gpu/drm/i915/i915_reg.h | 4 +++
drivers/gpu/drm/i915/intel_pm.c | 78 ++++++++++++++++++++++++++++++++++++++++-
2 files changed, 81 insertions(+), 1 deletion(-)
diff --git a/drivers/gpu/drm/i915/i915_reg.h b/drivers/gpu/drm/i915/i915_reg.h
index 3be449d..e48ed32 100644
--- a/drivers/gpu/drm/i915/i915_reg.h
+++ b/drivers/gpu/drm/i915/i915_reg.h
@@ -4967,6 +4967,10 @@
GEN6_PM_RP_DOWN_THRESHOLD | \
GEN6_PM_RP_DOWN_TIMEOUT)
+#define VLV_GTLC_SURVIVABILITY_REG 0x130098
+#define VLV_GFX_CLK_STATUS_BIT (1<<3)
+#define VLV_GFX_CLK_FORCE_ON_BIT (1<<2)
+
#define GEN6_GT_GFX_RC6_LOCKED 0x138104
#define VLV_COUNTER_CONTROL 0x138104
#define VLV_COUNT_RANGE_HIGH (1<<15)
diff --git a/drivers/gpu/drm/i915/intel_pm.c b/drivers/gpu/drm/i915/intel_pm.c
index 6b80ec4..347d77b 100644
--- a/drivers/gpu/drm/i915/intel_pm.c
+++ b/drivers/gpu/drm/i915/intel_pm.c
@@ -3581,12 +3581,87 @@ void gen6_set_rps(struct drm_device *dev, u8 val)
trace_intel_gpu_freq_change(val * 50);
}
+/* vlv_set_rps_idle: Set the frequency to Rpe if Gfx clocks are down
+ *
+ * If Gfx clock is UP, then reset the timer as there is a possibility
+ * that normal Turbo logic can bring down the freq to Rpe.
+ * If Gfx clock is Down, then
+ * 1. Mask Turbo interrupts
+ * 2. Bring up Gfx clock
+ * 3. Change the freq to Rpe and wait till P-Unit updates freq
+ * 4. Clear the Force GFX CLK ON bit so that Gfx can down
+ * 5. Unmask Turbo interrupts
+*/
+static void vlv_set_rps_idle(struct drm_i915_private *dev_priv)
+{
+
+ /*
+ * When we are idle. Drop to min voltage state.
+ * Note: we use RPe here since it should match the
+ * Vmin we were shooting for. That should give us better
+ * perf when we come back out of RC6 than if we used the
+ * min freq available.
+ */
+
+ if (dev_priv->rps.cur_delay <= dev_priv->rps.rpe_delay)
+ return;
+
+ if (I915_READ(VLV_GTLC_SURVIVABILITY_REG) & VLV_GFX_CLK_STATUS_BIT) {
+ /* GT is not power gated. Let's wait for normal
+ * Turbo Logic can bring down the freq to RPe.
+ * */
+ vlv_punit_write(dev_priv, PUNIT_REG_GPU_FREQ_REQ,
+ dev_priv->rps.rpe_delay);
+
+ /* Make sure Rpe is set by P-Unit*/
+ if (wait_for((vlv_update_rps_cur_delay(dev_priv) &&
+ (dev_priv->rps.cur_delay ==
+ dev_priv->rps.rpe_delay)), 100))
+ DRM_DEBUG_DRIVER("Not able to set Rpe\n");
+
+ } else {
+ /* When, Gfx clock is DOWN */
+
+ /* Mask turbo interrupt so that they will not come in between */
+ I915_WRITE(GEN6_PMINTRMSK, 0xffffffff);
+
+ /* Bring up the Gfx clock */
+ I915_WRITE(VLV_GTLC_SURVIVABILITY_REG,
+ I915_READ(VLV_GTLC_SURVIVABILITY_REG) |
+ VLV_GFX_CLK_FORCE_ON_BIT);
+
+ if (wait_for(((VLV_GFX_CLK_STATUS_BIT &
+ I915_READ(VLV_GTLC_SURVIVABILITY_REG)) != 0), 500)) {
+ DRM_ERROR("GFX_CLK_ON request timed out\n");
+ return;
+ }
+
+ vlv_punit_write(dev_priv, PUNIT_REG_GPU_FREQ_REQ,
+ dev_priv->rps.rpe_delay);
+
+ /* Make sure Rpe is set by P-Unit*/
+ if (wait_for((vlv_update_rps_cur_delay(dev_priv) &&
+ (dev_priv->rps.cur_delay ==
+ dev_priv->rps.rpe_delay)), 100))
+ DRM_DEBUG_DRIVER("Not able to set Rpe\n");
+
+ /* Release the Gfx clock */
+ I915_WRITE(VLV_GTLC_SURVIVABILITY_REG,
+ I915_READ(VLV_GTLC_SURVIVABILITY_REG) &
+ ~VLV_GFX_CLK_FORCE_ON_BIT);
+
+ /* Unmask Turbo interrupts */
+ I915_WRITE(GEN6_PMINTRMSK, ~GEN6_PM_RPS_EVENTS);
+ }
+}
+
+
void gen6_rps_idle(struct drm_i915_private *dev_priv)
{
mutex_lock(&dev_priv->rps.hw_lock);
if (dev_priv->rps.enabled) {
if (dev_priv->info->is_valleyview)
- valleyview_set_rps(dev_priv->dev, dev_priv->rps.min_delay);
+ vlv_set_rps_idle(dev_priv);
else
gen6_set_rps(dev_priv->dev, dev_priv->rps.min_delay);
dev_priv->rps.last_adj = 0;
@@ -4846,6 +4921,7 @@ void intel_gpu_ips_teardown(void)
i915_mch_dev = NULL;
spin_unlock_irq(&mchdev_lock);
}
+
static void intel_init_emon(struct drm_device *dev)
{
struct drm_i915_private *dev_priv = dev->dev_private;
--
1.8.4.2
_______________________________________________
Intel-gfx mailing list
Intel-gfx@xxxxxxxxxxxxxxxxxxxxx
http://lists.freedesktop.org/mailman/listinfo/intel-gfx
