Supposedly we should use the DAC divider for <300MHz pixel clocks, but as that doesn't actually work as well as the high freq divider here in practice, just use the high freq divider all the time. v2: remove unconditional write (Jesse) check for pixel rate properly (Jesse) v3: give up, the DAC divider apparently doesn't work, and low res modes work ok (Jesse) remove debug msg (Jesse) Signed-off-by: Jesse Barnes <jbarnes at virtuousgeek.org> --- drivers/gpu/drm/i915/intel_display.c | 11 +++++++---- 1 file changed, 7 insertions(+), 4 deletions(-) diff --git a/drivers/gpu/drm/i915/intel_display.c b/drivers/gpu/drm/i915/intel_display.c index 6504337..59c2114 100644 --- a/drivers/gpu/drm/i915/intel_display.c +++ b/drivers/gpu/drm/i915/intel_display.c @@ -4425,10 +4425,13 @@ static void vlv_update_pll(struct intel_crtc *crtc) mdiv |= ((bestp1 << DPIO_P1_SHIFT) | (bestp2 << DPIO_P2_SHIFT)); mdiv |= ((bestn << DPIO_N_SHIFT)); mdiv |= (1 << DPIO_K_SHIFT); - if (intel_pipe_has_type(&crtc->base, INTEL_OUTPUT_HDMI) || - intel_pipe_has_type(&crtc->base, INTEL_OUTPUT_EDP) || - intel_pipe_has_type(&crtc->base, INTEL_OUTPUT_DISPLAYPORT)) - mdiv |= (DPIO_POST_DIV_HDMIDP << DPIO_POST_DIV_SHIFT); + + /* + * Post divider depends on pixel clock rate, DAC vs digital (and LVDS, + * but we don't support that). + * Note: don't use the DAC post divider as it seems unstable. + */ + mdiv |= (DPIO_POST_DIV_HDMIDP << DPIO_POST_DIV_SHIFT); intel_dpio_write(dev_priv, DPIO_DIV(pipe), mdiv); mdiv |= DPIO_ENABLE_CALIBRATION; -- 1.7.10.4