From: Ville Syrjälä <ville.syrjala@xxxxxxxxxxxxxxx> DP v1.1+ says: "The DisplayPort transmitter, which is the driving end for a request transaction, pre-charges the AUX-CH+ and AUX-CH- to a common mode voltage by transmitting 10 to 16 consecutive 0’s in Manchester II code. After the active pre-charge, the transmitter sends an AUX Sync pattern. The AUX Sync pattern must be as follows: Start with 16 consecutive 0s in Manchester-II code, which results in a transition from low to high in the middle of each bit period. Including active pre-charge pulses, there shall be 26 to 32 consecutive 0s before the end of the AUX_SYNC pattern." BDW bspec says: "Used to determine the precharge time for the Aux Channel. During this time the Aux Channel will drive the SYNC pattern. Every microsecond gives one additional SYNC pulse beyond the hard coded 26 SYNC pulses. The value is the number of microseconds times 2. Default is 3 decimal which gives 6us of precharge which is 6 extra SYN pulses for a total of 32." CPT bspec says the same thing apart from: "... Default is 5 decimal which gives 10us of precharge which is 10 extra SYNC pulses for a total of 36." So it looks like to match the max of 32 of the DP spec we should just always program this extra precharge time to 3. Unfortunately g4x/ibx bspec doesn't have this clarification, but since the cpt default was still the same 5 as for g4x/ibx let's assume the behaviour was always the same. Signed-off-by: Ville Syrjälä <ville.syrjala@xxxxxxxxxxxxxxx> --- drivers/gpu/drm/i915/display/intel_dp_aux.c | 9 ++------- 1 file changed, 2 insertions(+), 7 deletions(-) diff --git a/drivers/gpu/drm/i915/display/intel_dp_aux.c b/drivers/gpu/drm/i915/display/intel_dp_aux.c index eaebf123310a..d5443d6d6123 100644 --- a/drivers/gpu/drm/i915/display/intel_dp_aux.c +++ b/drivers/gpu/drm/i915/display/intel_dp_aux.c @@ -126,12 +126,7 @@ static u32 g4x_get_aux_send_ctl(struct intel_dp *intel_dp, struct intel_digital_port *dig_port = dp_to_dig_port(intel_dp); struct drm_i915_private *dev_priv = to_i915(dig_port->base.base.dev); - u32 precharge, timeout; - - if (IS_GEN(dev_priv, 6)) - precharge = 3; - else - precharge = 5; + u32 timeout; if (IS_BROADWELL(dev_priv)) timeout = DP_AUX_CH_CTL_TIME_OUT_600us; @@ -145,7 +140,7 @@ static u32 g4x_get_aux_send_ctl(struct intel_dp *intel_dp, timeout | DP_AUX_CH_CTL_RECEIVE_ERROR | (send_bytes << DP_AUX_CH_CTL_MESSAGE_SIZE_SHIFT) | - (precharge << DP_AUX_CH_CTL_PRECHARGE_2US_SHIFT) | + (3 << DP_AUX_CH_CTL_PRECHARGE_2US_SHIFT) | (aux_clock_divider << DP_AUX_CH_CTL_BIT_CLOCK_2X_SHIFT); } -- 2.26.2 _______________________________________________ Intel-gfx mailing list Intel-gfx@xxxxxxxxxxxxxxxxxxxxx https://lists.freedesktop.org/mailman/listinfo/intel-gfx
