On Sat, 01 Dec 2012 16:47:46 +0000, Chris Wilson <chris at chris-wilson.co.uk> wrote: > On Sat, 1 Dec 2012 13:53:39 +0100, Daniel Vetter <daniel.vetter at ffwll.ch> wrote: > > Hi all, > > > > Irq-drive gmbus/dp aux transfer, simply because we can (and at least in the case > > of gmbus, it's quite a bit faster than the msleep(1) loop - we now reliably > > transfer at full wire speed insteaf of sometimes 2-3x slower). > > > > Compared to the older version I've floated on irc way back and which Chris has > > carried around in his wip branchs (and inflicted upon tons of unsuspecting bug > > reporters) there are a few differences: > > - handle the hpd vs. setup race - even the current code enables hpd processing > > before the fbdev is set up, which is too early. > > - fix the gen4 gmbus support, was totally busted. > > - tested on hsw (although all the relevant bits are a 100% match with cpt/ivb). > > - disable dp aux irq on vlv - too complicated to get at the docs (moved again, > > old access revoked) and I don't have the hw. > > > > While reviewing this patch series I've also noticed two small things in the irq > > handling code in general, patches for that at the beginning of the series. > > > > Comment&review highgly welcome. > > gm45 appears to be functioning big time, good start. The init sequence > looks less convoluted and better understood now, so I am reasonably > happy with this series. Will report back later after more testing. ilk: [ 0.698644] [drm:intel_dp_aux_wait_done] *ERROR* dp aux hw did not signal timeout (has irq: 1)! and slow -Chris -- Chris Wilson, Intel Open Source Technology Centre
