When we read the VBT t11_t12 value for panel power cycle delay,
it is a zero based value so we need to 100ms to that. And then it
needs to be multiplied by 10 to store it in 100usecs unit same as
SW VBT.
v3:
* Add it as part of series
v2:
* Change the VBT value instead of HW readout and pp div (Ville Syrjala)
Reviewed-by: Ville Syrjala <ville.syrjala@xxxxxxxxxxxxxxx>
Signed-off-by: Manasi Navare <manasi.d.navare@xxxxxxxxx>
Cc: Ville Syrjala <ville.syrjala@xxxxxxxxxxxxxxx>
Cc: Clint Taylor <clinton.a.taylor@xxxxxxxxx>
---
drivers/gpu/drm/i915/intel_dp.c | 5 +++++
1 file changed, 5 insertions(+)
diff --git a/drivers/gpu/drm/i915/intel_dp.c b/drivers/gpu/drm/i915/intel_dp.c
index bca4ac1..be9e17a 100644
--- a/drivers/gpu/drm/i915/intel_dp.c
+++ b/drivers/gpu/drm/i915/intel_dp.c
@@ -5234,6 +5234,11 @@ intel_dp_init_panel_power_sequencer(struct drm_device *dev,
intel_pps_dump_state("cur", &cur);
vbt = dev_priv->vbt.edp.pps;
+ /* T11_T12 delay is special and actually in units of 100ms, but zero
+ * based in the hw (so we need to add 100 ms). But the sw vbt
+ * table multiplies it with 1000 to make it in units of 100usec,
+ * too. */
+ vbt.t11_t12 += 100 * 10;
/* Upper limits from eDP 1.3 spec. Note that we use the clunky units of
* our hw here, which are all in 100usec. */
--
2.1.4
_______________________________________________
Intel-gfx mailing list
Intel-gfx@xxxxxxxxxxxxxxxxxxxxx
https://lists.freedesktop.org/mailman/listinfo/intel-gfx
