Ken,
Thanks for bringing out the requirement.
The very first sentence of the NVO3 charter is about “Support for multi-tenancy … of data centers”. If most VMs in Data Centers communicate with peers in different
subnets, then the inter-subnet communication should be addressed by NVO3 framework draft.
Maybe my interpretation of the charter wording is wrong. I will leave the interpretation job to ADs then.
Linda
From: Ken Gray (kegray) [mailto:kegray@xxxxxxxxx]
Sent: Saturday, May 24, 2014 11:57 AM
To: Linda Dunbar
Cc: ietf@xxxxxxxx; IETF-Announce; nvo3@xxxxxxxx
Subject: Re: [nvo3] Last Call: <draft-ietf-nvo3-framework-06.txt> (Framework for DC Network Virtualization) to Informational RFC
Hi, Linda. I just don't read a requirement to describe gateway functionality anywhere in … or into …the posted charter. The charter focuses primarily on the
the creation of scalable DCVPNs but seems to leave explicitly connecting DCVPNs together out. If you felt that was an oversight, it should have been addressed when we/nvo3 were chartered.
If the authors want to substitute interchangeable terms like gateway, router, inter-vpn for this generic boundary…I don't have any preference.
Otherwise, I'm for building no more than we need … and leaving purposely generic interfaces where work is out of scope … generic. We don't need specific examples
unless we're supposed to build something, and should resist the unnecessary bloat.
Ken,
If you prefer to call it “inter-subnets and/or domains routing” instead of gateway, it would be fine with me.
IMHO, the NVO3 framework draft should cover this key function of data center networking.
The illustrated example is only to show the normal across subnets/domains traffic pattern, to show why it is necessary for NVO3 to address inter-subnet/domain
issues.
The implication of inter-subnet/domain routing:
-
If a NVE performs the inter-subnet/domain routing, the NVE needs to have the needed policy. Some NVEs may have the needed policies for all VNs in
DC, some NVEs may only have portion of the policies, some NVEs may not have any.
-
For NVEs adjacent to the “DC Gateway” in the Figure 1 of the framework draft have to maintain the mappings for all hosts/VMs in DC. For large DCs
with Tens of Thousands (or hundreds of thousands) VMs, maintaining those mapping can be very intensive.
Hope the authors can also address those technical issues I brought up:
- Section 2.3.2. L3 NVE Providing IP/VRF-like forwarding
RFC4364 is about IP over MPLS network, i.e. the underlay is MPLS network. But NVO3’s underlay is IP.
- Page 13 Second bullet: the text says that each VNI is automatically generated by the egress NVE. Isn’t each VNI supposed to match a local virtual network (e.g. represented
by VLAN)? When the same NVE acts as Ingress NVE for the attached VMs, aren’t the VNI for ingress direction statically provisioned? Why need automatic egress VNI generation?
- Section 3.2 Multi-homing: LAG is usually used to bundle multiple ports on one device. In the multi-homing environment, there are multiple NVEs. Besides, LAG and STP
in the multi-homing environment can’t really prevent loop. You will need something like TRILL’s Appointed Forwarders to prevent loops in multi-homing environment.
Linda
From: Ken Gray (kegray) [mailto:kegray@xxxxxxxxx]
Sent: Friday, May 23, 2014 7:31 AM
To: Linda Dunbar
Cc: ietf@xxxxxxxx; IETF-Announce;
nvo3@xxxxxxxx
Subject: Re: [nvo3] Last Call: <draft-ietf-nvo3-framework-06.txt> (Framework for DC Network Virtualization) to Informational RFC
Ultimately, your "gateway" function is manifested as a forwarding entry. You're describing the mechanics of how that entry is derived. While there are aspects of map distribution that might affect those mechanics
- that are specific elements of nvo3, I don't think describing them at this point in the doc was the author's purpose (or necessary).
It appears to me that your comment is much more simple - that we have omitted (the obvious) "you probably need to route between subnets and/or domains". Which I suggest as the more generic text if you think their
example is insufficient.
Why illustrate A method of doing so? Why jump down the rabbit hole of "all possible ways this could manifest? None of that can be codified by this document.
Key,
Comments are inserted below:
From: Ken Gray (kegray) [mailto:kegray@xxxxxxxxx]
Sent: Thursday, May 22, 2014 2:58 PM
To: Linda Dunbar; ietf@xxxxxxxx; IETF-Announce
Cc: nvo3@xxxxxxxx
Subject: Re: [nvo3] Last Call: <draft-ietf-nvo3-framework-06.txt> (Framework for DC Network Virtualization) to Informational RFC
Personally, I think encap/decap manipulation is the essence of the "gateway" or inter-virtual network communication. To me, technically, all the NVEs are gateways
of a sort. You're just specifying that the permutations are variant (the network isn't homogenous in it's encap)?
[Linda] The encap/decap is only sending packets within one VN. For example,
when a host “a” in subnet “A” sends a packet to host “b” in subnet “B”, the MAC address from “a” is actually the gateway MAC address for subnet “A”. So the
Ingress NVE is the NVE to which that “a” is attached, and the egress NVE is the one that “A” gateway is attached (which are possibly collocated). The Gateway terminates the MAC header from host “a”, and relays the packet to “B” VN (i.e. subnet), add a new
MAC header (with DA=
“b” MAC, SA=Gateway MAC, and the associated VLAN), and sends out the newly constructed Ethernet packet. The NVE to which the Gateway is attached (or collocated) has to resolve the egress NVE to which “b” is attached, encap the packet and sends to the “b” NVE.
Some NVE can support Gateway function, i.e. IRB function as described in the Section 2.2. of
http://datatracker.ietf.org/doc/draft-yong-nvo3-frwk-dpreq-addition/.
More to the point, your drawing seems to imply that some sort of additional functionality other than a header fix-up in the NVE is required (Gateway function above
the NVE). While what is depicted CAN be an implementation of a gateway, logically … some control function (not necessarily local on that device …orchestration, controller, operator) could dictate/impose such a translation/transcription onto NVE at different
points in the infrastructure and achieve the same result/effect.
[Linda] The “gateway” can be embedded in some NVEs. But many NVEs can’t support gateway functions. In order to support gateway function, the NVE has to have
the inter-subnet policies, or access the Firewalls.
For example, subnet A can send packets to subnet B, but A can’t send to C. If NVEs are on servers, they may not have the needed policy to relay traffic between
two different subnets. The data packets may need to be sent to the designated gateways. The framework draft should address those issues.
So, if it's a generic drawing …we don't need specific examples (IMO) unless we want to rathole on implementations to avoid inferring one is preferred. If you
feel a need for a generic conceptional representation, then I'd advise tagging it as such and not associating any implementation details (which is what I think your yong doc pointer does).
[Linda] IMHO, the generic drawing should have components to handle inter-VN communication, instead of simple clone to L2VPN.
Linda
I have sent comments several times within NVO3 WG, but my comments hadn't been properly addressed.
So, I am sending them again; hopefully those comments can be addressed during the IETF last call.
NVO3 is about virtualization for data center (as stated in its charter statement). Inter-subnets communication (or inter Virtual Networks communication) is a big part (if not
major part) of data centers traffic. Hosts in one subnet frequently communicate with hosts in different subnets or peers external to DC.
Yet the current framework draft focuses so much on encapsulating/decapsulating TS traffic, making NVO3 a lot like L2VPN or L3VPN MPLS network. Since IETF already has dedicated
WGs for L2VPN and L3VPN, the NV03 WG should focus more on how inter-subnet communication is achieved in the overlay environment.
Here are the suggested changes:
- The current Figure2 (Generic Reference model of NVo3) is like a clone to L2VPN. The NVO3 context reference model needs to add a gateway entity, as shown below, for
relaying traffic from one VN to another VN.
| Tenant +--+ | +----| Tenant |
| System | | | (') | System |
+--------+ | ................ ( ) +--------+
- There are good inter virtual network descriptions in
http://datatracker.ietf.org/doc/draft-yong-nvo3-frwk-dpreq-addition/.
The content from this draft should be included in the general framework, especially:
2.2. L2-3 NVE Providing IP Routing/Bridging-like Service (Framework Addition)
L2-3 NVE is similar to IRB function on a router [CIRB] device today. It supports the TSes attached to the NVE (locally or remotely) to communicate with each other when they
are in a same route domain, i.e. a tenant virtual network. The NVE provides per tenant virtual switching and routing instance with address isolation and L3 tunnel encapsulation across the core. The L2-3 NVE supports the bridging among TSes that are on the
same subnet and the routing among TSes that are on the different subnets.
- Section 2.3.1. L2 NVE Providing Ethernet LAN-Like services:
Need to add a paragraph to address that great amount of traffic in DC is across VN (or across subnets). Need to describe how across subnet is performed. E.g. relayed at L2/L3
gateway.
- Section 2.3.2. L3 NVE Providing IP/VRF-like forwarding
RFC4364 is about IP over MPLS network, i.e. the underlay is MPLS network. But NVO3’s underlay is IP.
- Page 13 Second bullet: the text says that each VNI is automatically generated by the egress NVE. Isn’t each VNI supposed to match a local virtual network (e.g. represented
by VLAN)? When the same NVE acts as Ingress NVE for the attached VMs, aren’t the VNI for ingress direction statically provisioned? Why need automatic egress VNI generation?
- Section 3.2 Multi-homing: LAG is usually used to bundle multiple ports on one device. In the multi-homing environment, there are multiple NVEs. Besides, LAG and STP
in the multi-homing environment can’t really prevent loop. You will need something like TRILL’s Appointed Forwarders to prevent loops in multi-homing environment.
-----Original Message-----
From: nvo3 [mailto:nvo3-bounces@xxxxxxxx] On Behalf Of The IESG
Sent: Wednesday, May 21, 2014 9:33 AM
To: IETF-Announce
Cc: nvo3@xxxxxxxx
Subject: [nvo3] Last Call: <draft-ietf-nvo3-framework-06.txt> (Framework for DC Network Virtualization) to Informational RFC
The IESG has received a request from the Network Virtualization Overlays WG (nvo3) to consider the following document:
- 'Framework for DC Network Virtualization'
<draft-ietf-nvo3-framework-06.txt> as Informational RFC
The IESG plans to make a decision in the next few weeks, and solicits final comments on this action. Please send substantive comments to the
ietf@xxxxxxxx mailing lists by 2014-06-04. Exceptionally, comments may be sent to
iesg@xxxxxxxx instead. In either case, please retain the beginning of the Subject line to allow automated sorting.
This document provides a framework for Network Virtualization
Overlays (NVO3) and it defines a reference model along with logical
components required to design a solution.
The file can be obtained via
IESG discussion can be tracked via
No IPR declarations have been submitted directly on this I-D.
_______________________________________________
|