Set up the relay agent in your router to point at my DHCP server. - Ralph On 4/20/07 1:59 PM, "Hallam-Baker, Phillip" <pbaker@xxxxxxxxxxxx> wrote: > OK how do I DHCP to the server on your network from my desk here? > > (assuming that there are no NATs or firewalls) > > If it was pure IP it would work. > >> -----Original Message----- >> From: Ralph Droms [mailto:rdroms@xxxxxxxxx] >> Sent: Friday, April 20, 2007 1:57 PM >> To: Hallam-Baker, Phillip; David W. Hankins; ietf@xxxxxxxx >> Cc: GEOPRIV WG >> Subject: Re: [Geopriv] Confirmation of GEOPRIV IETF 68 >> Working Group Hums >> >> Huh? DHCP is carried in UDP and IP. There is a little >> funkiness in the >> DHCPv4 transport, which we wouldn't have need if IPv4 >> link-local addresses had been defined when RFC 2131 was >> published. DHCPv6 uses link-local addresses and garden-variety IPv6. >> >> - Ralph >> >> >> On 4/20/07 1:48 PM, "Hallam-Baker, Phillip" >> <pbaker@xxxxxxxxxxxx> wrote: >> >>> >>> >>>> From: David W. Hankins [mailto:David_Hankins@xxxxxxx] >>> >>>> On Thu, Apr 19, 2007 at 03:38:40PM -0700, Hallam-Baker, >> Phillip wrote: >>>>> DHCP is a layer 3 technology that talks directly to layer 2. >>>> >>>> DHCP is a technology that dynamically configures hosts. >>> >>> That's not the point, the point here is that DHCP is not an >> Internet protocol. >>> It is an IETF protocol but not an Internet protocol. It >> does not layer >>> on the IP stack. >>> >>> >>> _______________________________________________ >>> Ietf mailing list >>> Ietf@xxxxxxxx >>> https://www1.ietf.org/mailman/listinfo/ietf >> _______________________________________________ Ietf@xxxxxxxx https://www1.ietf.org/mailman/listinfo/ietf