Re: [Last-Call] [mpls] Rtgdir last call review of draft-ietf-mpls-p2mp-bfd-06

[bruno.decraene@xxxxxxxxxx]

Hi Greg,

 

My 2 cents (not following the draft).

Another typical option may be to allow the network operator to configure, on the egress, an acceptable delay before reporting to the root. The egress would then pick a random value in this range. Statically, the more egress the more spread the reports to the root, which a priori would be good for scaling.

It would be up to the network operator to configure the right delay depending on the number of the leaves and the need for fast reporting (or not).

 

Totally up to you, but that would have my vote as this is a typical issue. (granted this is more likely an issue with protocols handling thousands of customers, but even for MPLS LSR scaling, RSVP-TE scaling issues are not unheard)

 

Regards,

--Bruno

 

From: mpls <mpls-bounces@xxxxxxxx> On Behalf Of Greg Mirsky
Sent: Sunday, February 25, 2024 12:25 AM
To: Joel Halpern <jmh@xxxxxxxxxxxxxxx>
Cc: rtg-dir@xxxxxxxx; draft-ietf-mpls-p2mp-bfd.all@xxxxxxxx; last-call@xxxxxxxx; mpls@xxxxxxxx
Subject: Re: [mpls] Rtgdir last call review of draft-ietf-mpls-p2mp-bfd-06

 

Hi Joel,

thank you for the clarification. My idea is to use a rate limiter at the root of the p2mp LSP that may receive notifications from the leaves affected by the failure. I imagine that the threshold of the rate limiter might be exceeded and the notifications will be discarded. As a result, some notifications will be processed by the headend of the p2mp BFD session later, as the tails transmit notifications periodically until the receive the BFD Control message with the Final flag set.  Thus, we cannot avoid the congestion but mitigate the negative effect it might cause by extending the convergence. Does that make sense?

 

Regards,

Greg

 

On Sat, Feb 24, 2024 at 2:39 PM Joel Halpern <jmh@xxxxxxxxxxxxxxx> wrote:

That covers part of my concern.  But....  A failure near the root means that a lot of leaves will see failure, and they will all send notifications converging on the root.  Those notifications themselves, not just the final messages, seem able to cause congestion.  I am not sure what can be done about it, but we aren't allowed to ignore it.

Yours,

Joel

On 2/24/2024 3:34 PM, Greg Mirsky wrote:

Hi Joel,

thank you for your support of this work and the suggestion. Would the following update of the last paragraph of Section 5 help:

OLD TEXT:

   An ingress LSR that has received the BFD Control packet, as described

   above, sends the unicast IP/UDP encapsulated BFD Control packet with

   the Final (F) bit set to the egress LSR.

NEW TEXT:

   As described above, an ingress LSR that has received the BFD Control

   packet sends the unicast IP/UDP encapsulated BFD Control packet with

   the Final (F) bit set to the egress LSR.  In some scenarios, e.g.,

   when a p2mp LSP is broken close to its root, and the number of egress

   LSRs is significantly large, the control plane of the ingress LSR

   might be congested by the BFD Control packets transmitted by egress

   LSRs and the process of generating unicast BFD Control packets, as

   noted above.  To mitigate that, a BFD implementation that supports

   this specification is RECOMMENDED to use a rate limiter of received

   BFD Control packets passed to processing in the control plane of the

   ingress LSR.

 

Regards,

Greg

 

On Thu, Feb 22, 2024 at 4:10 PM Joel Halpern via Datatracker <noreply@xxxxxxxx> wrote:

Reviewer: Joel Halpern
Review result: Ready

Hello,

I have been selected as the Routing Directorate reviewer for this draft. The
Routing Directorate seeks to review all routing or routing-related drafts as
they pass through IETF last call and IESG review, and sometimes on special
request. The purpose of the review is to provide assistance to the Routing ADs.
For more information about the Routing Directorate, please see
https://wiki.ietf.org/en/group/rtg/RtgDir

Although these comments are primarily for the use of the Routing ADs, it would
be helpful if you could consider them along with any other IETF Last Call
comments that you receive, and strive to resolve them through discussion or by
updating the draft.

Document: draft-name-version
Reviewer: your-name
Review Date: date
IETF LC End Date: date-if-known
Intended Status: copy-from-I-D

Summary:  This document is ready for publication as a Proposed Standard.
    I do have one question that I would appreciate being considered.

Comments:
    The document is clear and readable, with careful references for those
    needing additional details.

Major Issues: None

Minor Issues:
    I note that the security considerations (section 6) does refer to
    congestion issues caused by excessive transmission of BFD requests.   I
    wonder if section 5 ("Operation of Multipoint BFD with Active Tail over
    P2MP MPLS LSP") should include a discussion of the congestion implications
    of multiple tails sending notifications at the rate of 1 per second to the
    head end, particularly if the failure is near the head end.  While I
    suspect that the 1 / second rate is low enough for this to be safe,
    discussion in the document would be helpful.

____________________________________________________________________________________________________________
Ce message et ses pieces jointes peuvent contenir des informations confidentielles ou privilegiees et ne doivent donc
pas etre diffuses, exploites ou copies sans autorisation. Si vous avez recu ce message par erreur, veuillez le signaler
a l'expediteur et le detruire ainsi que les pieces jointes. Les messages electroniques etant susceptibles d'alteration,
Orange decline toute responsabilite si ce message a ete altere, deforme ou falsifie. Merci.

This message and its attachments may contain confidential or privileged information that may be protected by law;
they should not be distributed, used or copied without authorisation.
If you have received this email in error, please notify the sender and delete this message and its attachments.
As emails may be altered, Orange is not liable for messages that have been modified, changed or falsified.
Thank you.

-- 
last-call mailing list
last-call@xxxxxxxx
https://www.ietf.org/mailman/listinfo/last-call