I think I this mail is more appropriate on the thinkpad_acpi mailing list: On 03/01/2010 01:25 PM, Tobias Grosser wrote: > Hi, > > I just got my thinkpad T410s 291239G. > More details can be found here: > http://www.thinkwiki.org/wiki/List_of_DMI_IDs > > I got an ericsson wan card installed by my vendor, but unfortunately it > does not work. > > I test with kernel 2.6.33 + patches as in ibm-acpi git. This is git > revision dbc47a5545406faf773aca159a2850f0c643c46f. > > During boot it is detected but disappears right afterwords. This looks > as the the resume problem recently discussed on the mailing list, > however after normal boot, with power switched off before. (This is > without thinkpad_acpi loaded, the same happens with thinkpad_acpi loaded) > > ----------------------------------------------------------------- > [ 1.969332] usbcore: registered new interface driver cdc_acm > [ 1.969334] cdc_acm: v0.26:USB Abstract Control Model driver for USB > modems and ISDN adapters > [ 1.969387] usbcore: registered new interface driver usblp > [ 1.969424] usbcore: registered new interface driver cdc_wdm > [ 1.969426] Initializing USB Mass Storage driver... > [ 1.969481] usbcore: registered new interface driver usb-storage > [ 1.969483] USB Mass Storage support registered. > [ 1.969544] usbcore: registered new interface driver libusual > [ 3.579460] cdc_acm 2-1.4:1.1: usb_probe_interface > [ 3.579465] cdc_acm 2-1.4:1.1: usb_probe_interface - got id > [ 3.579543] cdc_acm 2-1.4:1.1: ttyACM0: USB ACM device > [ 3.582783] usb 2-1.4: adding 2-1.4:1.2 (config #1, interface 2) > [ 3.585342] usb 2-1.4:1.2: uevent > [ 3.585501] usb 2-1.4: adding 2-1.4:1.3 (config #1, interface 3) > [ 3.587849] usb 2-1.4:1.3: uevent > [ 3.588026] cdc_acm 2-1.4:1.3: usb_probe_interface > [ 3.588031] cdc_acm 2-1.4:1.3: usb_probe_interface - got id > [ 3.588110] cdc_acm 2-1.4:1.3: ttyACM1: USB ACM device > [ 3.591192] usb 2-1.4: adding 2-1.4:1.4 (config #1, interface 4) > [ 3.593206] usb 2-1.4:1.4: uevent > [ 3.593455] usb 2-1.4: adding 2-1.4:1.5 (config #1, interface 5) > [ 3.595463] usb 2-1.4:1.5: uevent > [ 3.595647] cdc_wdm 2-1.4:1.5: usb_probe_interface > [ 3.595651] cdc_wdm 2-1.4:1.5: usb_probe_interface - got id > [ 3.595659] drivers/usb/core/file.c: looking for a minor, starting at 176 > [ 3.596103] cdc_wdm 2-1.4:1.5: cdc-wdm0: USB WDM device > [ 3.598517] usb 2-1.4: adding 2-1.4:1.6 (config #1, interface 6) > [ 3.600580] usb 2-1.4:1.6: uevent > [ 3.600821] cdc_wdm 2-1.4:1.6: usb_probe_interface > [ 3.600826] cdc_wdm 2-1.4:1.6: usb_probe_interface - got id > [ 3.600833] drivers/usb/core/file.c: looking for a minor, starting at 176 > [ 3.600976] cdc_wdm 2-1.4:1.6: cdc-wdm1: USB WDM device > [ 3.603429] usb 2-1.4: adding 2-1.4:1.7 (config #1, interface 7) > [ 3.605461] usb 2-1.4:1.7: uevent > [ 3.605665] usb 2-1.4: adding 2-1.4:1.8 (config #1, interface 8) > [ 3.607557] usb 2-1.4:1.8: uevent > [ 3.607801] usb 2-1.4: adding 2-1.4:1.9 (config #1, interface 9) > [ 3.609661] usb 2-1.4:1.9: uevent > [ 3.609922] cdc_acm 2-1.4:1.9: usb_probe_interface > [ 3.609927] cdc_acm 2-1.4:1.9: usb_probe_interface - got id > [ 3.610011] cdc_acm 2-1.4:1.9: ttyACM2: USB ACM device > [ 3.613202] usb 2-1.4: adding 2-1.4:1.10 (config #1, interface 10) > [ 3.615167] usb 2-1.4:1.10: uevent > [ 3.615363] drivers/usb/core/inode.c: creating file '004' > [ 3.615391] hub 2-1:1.0: state 7 ports 8 chg 0000 evt 0004 > [ 3.635770] ata6: SATA link down (SStatus 0 SControl 300) > [ 3.648633] Freeing unused kernel memory: 508k freed > [ 3.651329] Write protecting the kernel read-only data: 12288k > [ 3.654612] Freeing unused kernel memory: 1860k freed > [ 3.657938] Freeing unused kernel memory: 1456k freed > [ 4.010913] async/0 used greatest stack depth: 4696 bytes left > [ 8.967921] IBM TrackPoint firmware: 0x0e, buttons: 3/3 > [ 9.227043] input: TPPS/2 IBM TrackPoint as > /devices/platform/i8042/serio1/serio2/input/input8 > [ 11.420024] hub 2-1:1.0: state 7 ports 8 chg 0000 evt 0010 > [ 11.420304] hub 2-1:1.0: port 4, status 0100, change 0001, 12 Mb/s > [ 11.420444] usb 2-1.4: USB disconnect, address 4 > [ 11.420451] usb 2-1.4: unregistering device > [ 11.420455] usb 2-1.4: usb_disable_device nuking all URBs > [ 11.420463] usb 2-1.4: unregistering interface 2-1.4:1.0 > [ 11.420490] usb 2-1.4:1.0: uevent > [ 11.420609] usb 2-1.4: unregistering interface 2-1.4:1.1 > [ 11.420769] usb 2-1.4:1.1: uevent > [ 11.420831] usb 2-1.4: unregistering interface 2-1.4:1.2 > [ 11.420858] usb 2-1.4:1.2: uevent > [ 11.420919] usb 2-1.4: unregistering interface 2-1.4:1.3 > [ 11.421037] usb 2-1.4:1.3: uevent > [ 11.421094] usb 2-1.4: unregistering interface 2-1.4:1.4 > [ 11.421122] usb 2-1.4:1.4: uevent > [ 11.421255] usb 2-1.4: unregistering interface 2-1.4:1.5 > [ 11.421278] drivers/usb/core/file.c: removing 176 minor > [ 11.421350] ehci_hcd 0000:00:1d.0: dma_pool_free buffer-2048, > ffff8800bac3e300/bac3e300 (bad dma) > [ 11.421360] usb 2-1.4:1.5: uevent > [ 11.421418] usb 2-1.4: unregistering interface 2-1.4:1.6 > [ 11.421440] drivers/usb/core/file.c: removing 177 minor > [ 11.421507] ehci_hcd 0000:00:1d.0: dma_pool_free buffer-2048, > ffff8800bac3e380/bac3e380 (bad dma) > [ 11.421516] usb 2-1.4:1.6: uevent > [ 11.421640] usb 2-1.4: unregistering interface 2-1.4:1.7 > [ 11.421663] usb 2-1.4:1.7: uevent > [ 11.421724] usb 2-1.4: unregistering interface 2-1.4:1.8 > [ 11.421739] usb 2-1.4:1.8: uevent > [ 11.421798] usb 2-1.4: unregistering interface 2-1.4:1.9 > [ 11.421914] usb 2-1.4:1.9: uevent > [ 11.421970] usb 2-1.4: unregistering interface 2-1.4:1.10 > [ 11.421998] usb 2-1.4:1.10: uevent > [ 11.422176] usb 2-1.4: uevent > ----------------------------------------------------------------- > > Thinkpad acpi detects wan support, but thinks the card is not installed. > [ 216.411030] thinkpad_acpi: ibm_init: probing for wan > [ 216.411032] thinkpad_acpi: wan_init: initializing wan subdriver > [ 216.411035] thinkpad_acpi: drv_acpi_handle_init: trying to locate ACPI > handle for hkey > [ 216.411042] thinkpad_acpi: drv_acpi_handle_init: Found ACPI handle > HKEY for hkey > [ 216.411326] thinkpad_acpi: wan_init: wan is supported, status 0x04 > [ 216.411328] thinkpad_acpi: wan_init: wan hardware not installed > > Unfortunately I have not tested with windows, but the card is in the > machine so it should work if the card is not defect. > > The bluetooth card on the other hand can be disabled/enabled and > disappears/appears as it should in lsusb. wan does never show up. > > Is there anything I can do to debug this, without installing windows? > > Furthermore I have some smaller issues: > tobias% cat /proc/acpi/ibm/volume > level: unsupported > mute: offtobias > > Sends normal key events. That seems to be ok. > > % cat /proc/acpi/ibm/thermal > temperatures: 42 0 0 0 0 0 0 0 > > Just one sensor? > > Thanks a lot > > Tobi Sorry for sending it to the wrong list at the first try. Tobi ------------------------------------------------------------------------------ Download Intel® Parallel Studio Eval Try the new software tools for yourself. Speed compiling, find bugs proactively, and fine-tune applications for parallel performance. See why Intel Parallel Studio got high marks during beta. http://p.sf.net/sfu/intel-sw-dev _______________________________________________ ibm-acpi-devel mailing list ibm-acpi-devel@xxxxxxxxxxxxxxxxxxxxx https://lists.sourceforge.net/lists/listinfo/ibm-acpi-devel
