[PATCH][drivers/misc/thinkpad_acpi.c] duplicate test if (level & TP_EC_FAN_FULLSPEED)

[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

 



Roland Dreier wrote:
>  >                 /* safety net should the EC not support AUTO
>  >                  * or FULLSPEED mode bits and just ignore them */
>  >                 if (level & TP_EC_FAN_FULLSPEED)
>  >                         level |= 7;     /* safety min speed 7 */
>  >                 else if (level & TP_EC_FAN_FULLSPEED)
>  >                         level |= 4;     /* safety min speed 4 */
>  > 
>  > Note the duplicate test 'if (level & TP_EC_FAN_FULLSPEED)'. should
>  > this be replaced by
> 
> Actually I suspect one of the two tests should be against TP_EC_FAN_AUTO
> (based on the comment).
> 

Thanks Roland, for your info

based on the comments in commit eaa7571b2d1a08873e4bdd8e6db3431df61cd9ad,
I think this should be modified like below:

ACPI: thinkpad-acpi: add a safety net for TPEC fan control mode
The Linux ThinkPad community is not positive that all ThinkPads that do
HFSP EC fan control do implement full-speed and auto modes, some of the
earlier ones supporting HFSP might not.

If the EC ignores the AUTO or FULL-SPEED bits, it will pay attention to the
lower three bits that set the fan level. And as thinkpad-acpi was leaving
these set to zero, it would stop(!) the fan, which is Not A Good Thing.
So, as a safety net, we now make sure to also set the fan level part of the
HFSP register to speed 7 for full-speed, and a minimum of speed 4 for auto
mode.
--
second TP_EC_FAN_FULLSPEED should be P_EC_FAN_AUTO


Signed-off-by: Roel Kluin <12o3l@xxxxxxxxxx>
---
diff --git a/drivers/misc/thinkpad_acpi.c b/drivers/misc/thinkpad_acpi.c
index cf56647..3c323fe 100644
--- a/drivers/misc/thinkpad_acpi.c
+++ b/drivers/misc/thinkpad_acpi.c
@@ -4138,7 +4138,7 @@ static int fan_set_level(int level)
 		 * or FULLSPEED mode bits and just ignore them */
 		if (level & TP_EC_FAN_FULLSPEED)
 			level |= 7;	/* safety min speed 7 */
-		else if (level & TP_EC_FAN_FULLSPEED)
+		else if (level & TP_EC_FAN_AUTO)
 			level |= 4;	/* safety min speed 4 */
 
 		if (!acpi_ec_write(fan_status_offset, level))


-------------------------------------------------------------------------
This SF.net email is sponsored by: Microsoft
Defy all challenges. Microsoft(R) Visual Studio 2008.
http://clk.atdmt.com/MRT/go/vse0120000070mrt/direct/01/
_______________________________________________
ibm-acpi-devel mailing list
ibm-acpi-devel@xxxxxxxxxxxxxxxxxxxxx
https://lists.sourceforge.net/lists/listinfo/ibm-acpi-devel

[Index of Archives]     [Linux ACPI]     [Linux Kernel]     [Linux Laptop]     [Kernel Newbies]     [Share Photos]     [Security]     [Netfilter]     [Bugtraq]     [Photo]     [Yosemite Photos]     [Yosemite Advice]     [MIPS Linux]     [ARM Linux]     [Linux Security]     [Linux RAID]     [Samba]     [Device Mapper]

  Powered by Linux