On 11/13/2010 05:38 PM, Yinghai Lu wrote:
> Index: linux-2.6/arch/x86/kernel/acpi/boot.c
> ===================================================================
> --- linux-2.6.orig/arch/x86/kernel/acpi/boot.c
> +++ linux-2.6/arch/x86/kernel/acpi/boot.c
> @@ -198,6 +198,13 @@ static void __cpuinit acpi_register_lapi
> {
> unsigned int ver = 0;
>
> +#ifdef CONFIG_X86_64
> + if (id >= (MAX_APICS-1)) {
> + printk(KERN_INFO PREFIX "skipped apicid that is too big\n");
> + return;
> + }
> +#endif
> +
> if (!enabled) {
> ++disabled_cpus;
> return;
Why the #ifdef?
> Index: linux-2.6/arch/x86/mm/srat_64.c
> ===================================================================
> --- linux-2.6.orig/arch/x86/mm/srat_64.c
> +++ linux-2.6/arch/x86/mm/srat_64.c
> @@ -134,6 +134,10 @@ acpi_numa_x2apic_affinity_init(struct ac
> }
>
> apic_id = pa->apic_id;
> + if (apic_id >= MAX_LOCAL_APIC) {
> + printk(KERN_INFO "SRAT: PXM %u -> APIC 0x%04x -> Node %u skipped that apicid too big\n", pxm, apic_id, node);
> + return;
> + }
> apicid_to_node[apic_id] = node;
> node_set(node, cpu_nodes_parsed);
> acpi_numa = 1;
> @@ -168,6 +172,10 @@ acpi_numa_processor_affinity_init(struct
> apic_id = (pa->apic_id << 8) | pa->local_sapic_eid;
> else
> apic_id = pa->apic_id;
> + if (apic_id >= MAX_LOCAL_APIC) {
> + printk(KERN_INFO "SRAT: PXM %u -> APIC 0x%02x -> Node %u skipped apicid that is too big\n", pxm, apic_id, node);
> + return;
> + }
> apicid_to_node[apic_id] = node;
> node_set(node, cpu_nodes_parsed);
> acpi_numa = 1;
> Index: linux-2.6/drivers/acpi/numa.c
> ===================================================================
> --- linux-2.6.orig/drivers/acpi/numa.c
> +++ linux-2.6/drivers/acpi/numa.c
> @@ -275,13 +275,23 @@ acpi_table_parse_srat(enum acpi_srat_typ
> int __init acpi_numa_init(void)
> {
> int ret = 0;
> + int nr_cpu_entries = nr_cpu_ids;
> +
> +#ifdef CONFIG_X86_64
> + /*
> + * Should not limit number with cpu num that will handle,
> + * SRAT cpu entries could have different order with that in MADT.
> + * So go over all cpu entries in SRAT to get apicid to node mapping.
> + */
> + nr_cpu_entries = MAX_LOCAL_APIC;
> +#endif
>
Same here...
-hpa
--
To unsubscribe from this list: send the line "unsubscribe linux-hotplug" in
the body of a message to majordomo@xxxxxxxxxxxxxxx
More majordomo info at http://vger.kernel.org/majordomo-info.html
