The results of the first scan are still available when scanning for all networks and within 10 seconds scanning again but for specific frequencie(s). Even if 'BSS_FLUSH' used in between. See exaple: > SCAN OK <3>CTRL-EVENT-SCAN-STARTED <3>CTRL-EVENT-SCAN-RESULTS <3>WPS-AP-AVAILABLE <3>CTRL-EVENT-NETWORK-NOT-FOUND > SCAN_RESULTS bssid / frequency / signal level / flags / ssid aa:aa:aa:aa:aa:aa 5180 -42 [WPA2-PSK+SAE-CCMP][WPS][ESS] AP1 bb:bb:bb:bb:bb:bb 5180 -66 [WPA2-PSK+SAE-CCMP][ESS] AP2 cc:cc:cc:cc:cc:cc 2437 -56 [WPA2-PSK-CCMP][ESS] AP3 dd:dd:dd:dd:dd:dd 2462 -91 [WPA2-PSK-CCMP][ESS] AP4 // so far all ok. now flush cache and scan only one frequency > BSS_FLUSH OK > SCAN only_new=1 freq=2462 OK <3>CTRL-EVENT-SCAN-STARTED <3>CTRL-EVENT-SCAN-RESULTS <3>WPS-AP-AVAILABLE <3>CTRL-EVENT-NETWORK-NOT-FOUND > SCAN_RESULTS bssid / frequency / signal level / flags / ssid aa:aa:aa:aa:aa:aa 5180 -42 [WPA2-PSK+SAE-CCMP][WPS][ESS] AP1 bb:bb:bb:bb:bb:bb 5180 -66 [WPA2-PSK+SAE-CCMP][ESS] AP2 cc:cc:cc:cc:cc:cc 2437 -56 [WPA2-PSK-CCMP][ESS] AP3 dd:dd:dd:dd:dd:dd 2462 -90 [WPA2-PSK-CCMP][ESS] AP4 // it replies with same results as if no 'freq=' was set // if checking with 'BSS ID-0' -> same result, nothing flushed // flush again, or wait 10s, scan again > BSS_FLUSH OK > SCAN only_new=1 freq=2462 OK <3>CTRL-EVENT-SCAN-STARTED <3>CTRL-EVENT-SCAN-RESULTS <3>CTRL-EVENT-NETWORK-NOT-FOUND > SCAN_RESULTS bssid / frequency / signal level / flags / ssid dd:dd:dd:dd:dd:dd 2462 -88 [WPA2-PSK-CCMP][ESS] AP4 // works now Anyone got an idea what am I doing or what's going wrong? _______________________________________________ Hostap mailing list Hostap@xxxxxxxxxxxxxxxxxxx http://lists.infradead.org/mailman/listinfo/hostap
