[PATCH 05/12] hwsim: Stop WPA AP at end of VHT 80 MHz (US) test

[Andrei Otcheretianski <andrei.otcheretianski@xxxxxxxxx>]

From: Benjamin Berg <benjamin.berg@xxxxxxxxx>

The regulatory domain cannot be reset while the AP is still active. Add
the appropriate commands to bring down the AP after the test, which will
also make resetting the regulatory domain work.

Signed-off-by: Benjamin Berg <benjamin.berg@xxxxxxxxx>
---
 tests/hwsim/test_wpas_ap.py | 2 ++
 1 file changed, 2 insertions(+)

diff --git a/tests/hwsim/test_wpas_ap.py b/tests/hwsim/test_wpas_ap.py
index 7090f23e4a..67a34cd613 100644
--- a/tests/hwsim/test_wpas_ap.py
+++ b/tests/hwsim/test_wpas_ap.py
@@ -795,6 +795,8 @@ def run_wpas_ap_open_vht80_us(dev, freq, center_freq, ht40):
         if "WIDTH=80 MHz" not in sig:
             raise Exception("Unexpected SIGNAL_POLL value(2): " + str(sig))
     finally:
+        dev[0].request("REMOVE_NETWORK all")
+        dev[0].wait_disconnected()
         set_country("00")
         dev[0].set("country", "00")
         dev[1].flush_scan_cache()
-- 
2.43.0


_______________________________________________
Hostap mailing list
Hostap@xxxxxxxxxxxxxxxxxxx
http://lists.infradead.org/mailman/listinfo/hostap