From: Yegor Yefremov <yegorslists@xxxxxxxxxxxxxx> So far, this option was only present in the Makefiles. So make it available for configuration. Signed-off-by: Yegor Yefremov <yegorslists@xxxxxxxxxxxxxx> --- hostapd/defconfig | 3 +++ wpa_supplicant/defconfig | 3 +++ 2 files changed, 6 insertions(+) diff --git a/hostapd/defconfig b/hostapd/defconfig index 611f96ffa..2331ec088 100644 --- a/hostapd/defconfig +++ b/hostapd/defconfig @@ -164,6 +164,9 @@ CONFIG_IPV6=y # Simultaneous Authentication of Equals (SAE), WPA3-Personal #CONFIG_SAE=y +# SAE Public Key, WPA3-Personal +#CONFIG_SAE_PK=y + # Remove debugging code that is printing out debug messages to stdout. # This can be used to reduce the size of the hostapd considerably if debugging # code is not needed. diff --git a/wpa_supplicant/defconfig b/wpa_supplicant/defconfig index a4719dbb5..cb592163a 100644 --- a/wpa_supplicant/defconfig +++ b/wpa_supplicant/defconfig @@ -248,6 +248,9 @@ CONFIG_CTRL_IFACE=y # Simultaneous Authentication of Equals (SAE), WPA3-Personal CONFIG_SAE=y +# SAE Public Key, WPA3-Personal +#CONFIG_SAE_PK=y + # Disable scan result processing (ap_scan=1) to save code size by about 1 kB. # This can be used if ap_scan=1 mode is never enabled. #CONFIG_NO_SCAN_PROCESSING=y -- 2.17.0 _______________________________________________ Hostap mailing list Hostap@xxxxxxxxxxxxxxxxxxx http://lists.infradead.org/mailman/listinfo/hostap