I have two stations connected to an access point. The stations can communicate with each other. According to the docs, hostapd allows this low-level bridging by default. If I set the ap_isolate=1, the bridging is disabled and the stations cannot communicate. However, it appears the the frames are not forwarded upstream either. Is there a way to disable the bridging done by hostapd and make it forward all frames from connected stations? Will per_sta_vif=1 be of any use? Regards. Mark K Vallevand Cats were once worshiped as gods. They have not forgotten this. - Terry Pratchett _______________________________________________ Hostap mailing list Hostap@xxxxxxxxxxxxxxxxxxx http://lists.infradead.org/mailman/listinfo/hostap