Hello all With 802.11n 5 ghz with 40 mhz channel the client connect at only 150 mbps, while the wifi interface reports 300mbps. Is my hostapd config wrong ? Can I enable second spatial stream to have 150 mbps x2 ? hostapd config ------------------- interface=wlx54c9ff001484 driver=nl80211 # IEEE 802.11 ssid=somename hw_mode=a channel=36 auth_algs=1 # DFS country_code=RO ieee80211d=0 ieee80211h=0 # 802.11n ieee80211n=1 require_ht=1 ht_capab=[HT40+][SHORT-GI-20][SHORT-GI-40][DSSS_CCK-40][TX-STBC-12][RX-STBC-12] # 802.11i wpa=2 wpa_key_mgmt=WPA-PSK rsn_pairwise=TKIP CCMP wpa_passphrase=somepassword ----------------------- --------------------- wlx54c9ff001484 IEEE 802.11bgn ESSID:"somename" Nickname:"<WIFI@REALTEK>" Mode:Master Frequency:5.18 GHz Access Point: 54:C9:FF:00:14:84 Bit Rate:300 Mb/s Sensitivity:0/0 Retry:off RTS thr:off Fragment thr:off Encryption key:off Power Management:off Link Quality:0 Signal level:0 Noise level:0 Rx invalid nwid:0 Rx invalid crypt:0 Rx invalid frag:0 Tx excessive retries:0 Invalid misc:0 Missed beacon:0 ---------------------- -------------------- Wiphy phy5 max # scan SSIDs: 9 max scan IEs length: 2304 bytes max # sched scan SSIDs: 0 max # match sets: 0 max # scan plans: 1 max scan plan interval: -1 max scan plan iterations: 0 Retry short limit: 7 Retry long limit: 4 Coverage class: 0 (up to 0m) Supported Ciphers: * WEP40 (00-0f-ac:1) * WEP104 (00-0f-ac:5) * TKIP (00-0f-ac:2) * CCMP-128 (00-0f-ac:4) * CMAC (00-0f-ac:6) Available Antennas: TX 0 RX 0 Supported interface modes: * IBSS * managed * AP * monitor Band 1: Capabilities: 0x1962 HT20/HT40 Static SM Power Save RX HT20 SGI RX HT40 SGI RX STBC 1-stream Max AMSDU length: 7935 bytes DSSS/CCK HT40 Maximum RX AMPDU length 65535 bytes (exponent: 0x003) Minimum RX AMPDU time spacing: 16 usec (0x07) HT Max RX data rate: 300 Mbps HT TX/RX MCS rate indexes supported: 0-15 Bitrates (non-HT): * 1.0 Mbps * 2.0 Mbps * 5.5 Mbps * 11.0 Mbps * 6.0 Mbps * 9.0 Mbps * 12.0 Mbps * 18.0 Mbps * 24.0 Mbps * 36.0 Mbps * 48.0 Mbps * 54.0 Mbps Frequencies: * 2412 MHz [1] (30.0 dBm) * 2417 MHz [2] (30.0 dBm) * 2422 MHz [3] (30.0 dBm) * 2427 MHz [4] (30.0 dBm) * 2432 MHz [5] (30.0 dBm) * 2437 MHz [6] (30.0 dBm) * 2442 MHz [7] (30.0 dBm) * 2447 MHz [8] (30.0 dBm) * 2452 MHz [9] (30.0 dBm) * 2457 MHz [10] (30.0 dBm) * 2462 MHz [11] (30.0 dBm) * 2467 MHz [12] (30.0 dBm) (no IR) * 2472 MHz [13] (30.0 dBm) (no IR) * 2484 MHz [14] (disabled) Band 2: Capabilities: 0x1962 HT20/HT40 Static SM Power Save RX HT20 SGI RX HT40 SGI RX STBC 1-stream Max AMSDU length: 7935 bytes DSSS/CCK HT40 Maximum RX AMPDU length 65535 bytes (exponent: 0x003) Minimum RX AMPDU time spacing: 16 usec (0x07) HT Max RX data rate: 300 Mbps HT TX/RX MCS rate indexes supported: 0-15 VHT Capabilities (0x03c031a2): Max MPDU length: 11454 Supported Channel Width: neither 160 nor 80+80 short GI (80 MHz) TX STBC SU Beamformee +HTC-VHT VHT RX MCS set: 1 streams: MCS 0-9 2 streams: MCS 0-9 3 streams: not supported 4 streams: not supported 5 streams: not supported 6 streams: not supported 7 streams: not supported 8 streams: not supported VHT RX highest supported: 867 Mbps VHT TX MCS set: 1 streams: MCS 0-9 2 streams: MCS 0-9 3 streams: not supported 4 streams: not supported 5 streams: not supported 6 streams: not supported 7 streams: not supported 8 streams: not supported VHT TX highest supported: 867 Mbps Bitrates (non-HT): * 6.0 Mbps * 9.0 Mbps * 12.0 Mbps * 18.0 Mbps * 24.0 Mbps * 36.0 Mbps * 48.0 Mbps * 54.0 Mbps Frequencies: * 5180 MHz [36] (30.0 dBm) * 5200 MHz [40] (30.0 dBm) * 5220 MHz [44] (30.0 dBm) * 5240 MHz [48] (30.0 dBm) * 5260 MHz [52] (30.0 dBm) (no IR, radar detection) * 5280 MHz [56] (30.0 dBm) (no IR, radar detection) * 5300 MHz [60] (30.0 dBm) (no IR, radar detection) * 5320 MHz [64] (30.0 dBm) (no IR, radar detection) * 5500 MHz [100] (30.0 dBm) (no IR, radar detection) * 5520 MHz [104] (30.0 dBm) (no IR, radar detection) * 5540 MHz [108] (30.0 dBm) (no IR, radar detection) * 5560 MHz [112] (30.0 dBm) (no IR, radar detection) * 5580 MHz [116] (30.0 dBm) (no IR, radar detection) * 5600 MHz [120] (30.0 dBm) (no IR, radar detection) * 5620 MHz [124] (30.0 dBm) (no IR, radar detection) * 5640 MHz [128] (30.0 dBm) (no IR, radar detection) * 5660 MHz [132] (30.0 dBm) (no IR, radar detection) * 5680 MHz [136] (30.0 dBm) (no IR, radar detection) * 5700 MHz [140] (30.0 dBm) (no IR, radar detection) * 5720 MHz [144] (disabled) * 5745 MHz [149] (30.0 dBm) * 5765 MHz [153] (30.0 dBm) * 5785 MHz [157] (30.0 dBm) * 5805 MHz [161] (30.0 dBm) * 5825 MHz [165] (30.0 dBm) * 5845 MHz [169] (disabled) * 5865 MHz [173] (disabled) * 5885 MHz [177] (disabled) Supported commands: * new_interface * set_interface * new_key * start_ap * new_station * set_bss * join_ibss * set_pmksa * del_pmksa * flush_pmksa * frame * set_channel * connect * disconnect Supported TX frame types: * IBSS: 0x00 0x10 0x20 0x30 0x40 0x50 0x60 0x70 0x80 0x90 0xa0 0xb0 0xc0 0xd0 0xe0 0xf0 * managed: 0x00 0x10 0x20 0x30 0x40 0x50 0x60 0x70 0x80 0x90 0xa0 0xb0 0xc0 0xd0 0xe0 0xf0 * AP: 0x00 0x10 0x20 0x30 0x40 0x50 0x60 0x70 0x80 0x90 0xa0 0xb0 0xc0 0xd0 0xe0 0xf0 * AP/VLAN: 0x00 0x10 0x20 0x30 0x40 0x50 0x60 0x70 0x80 0x90 0xa0 0xb0 0xc0 0xd0 0xe0 0xf0 * P2P-client: 0x00 0x10 0x20 0x30 0x40 0x50 0x60 0x70 0x80 0x90 0xa0 0xb0 0xc0 0xd0 0xe0 0xf0 * P2P-GO: 0x00 0x10 0x20 0x30 0x40 0x50 0x60 0x70 0x80 0x90 0xa0 0xb0 0xc0 0xd0 0xe0 0xf0 Supported RX frame types: * IBSS: 0xd0 * managed: 0x40 0xb0 0xd0 * AP: 0x00 0x20 0x40 0xa0 0xb0 0xc0 0xd0 * AP/VLAN: 0x00 0x20 0x40 0xa0 0xb0 0xc0 0xd0 * P2P-client: 0x40 0xd0 * P2P-GO: 0x00 0x20 0x40 0xa0 0xb0 0xc0 0xd0 WoWLAN support: * wake up on anything (device continues operating normally) software interface modes (can always be added): * monitor interface combinations are not supported Device supports SAE with AUTHENTICATE command Device supports scan flush. ---------------------------------- Thanks. _______________________________________________ Hostap mailing list Hostap@xxxxxxxxxxxxxxxxxxx http://lists.infradead.org/mailman/listinfo/hostap
