From: Peter Oh <peter.oh@xxxxxxxxxxxxxxxxx> Mesh interface has used its channel parameters that configured during its initialization even after channel switched due to DFS radar detection during CAC which caused channel switch error. This change fixes the error by updating its channel parameters when channel's been changed from initial one. Signed-off-by: Peter Oh <peter.oh@xxxxxxxxxxxxxxxxx> --- wpa_supplicant/mesh.c | 25 +++++++++++++++++++++++++ 1 file changed, 25 insertions(+) diff --git a/wpa_supplicant/mesh.c b/wpa_supplicant/mesh.c index 3cbfcf3..eb36ef8 100644 --- a/wpa_supplicant/mesh.c +++ b/wpa_supplicant/mesh.c @@ -396,10 +396,35 @@ void wpa_supplicant_mesh_add_scan_ie(struct wpa_supplicant *wpa_s, void wpas_mesh_complete_cb(void *ctx) { struct wpa_supplicant *wpa_s = (struct wpa_supplicant *)ctx; + struct hostapd_iface *ifmsh = wpa_s->ifmsh; struct wpa_driver_mesh_join_params *params = wpa_s->mesh_params; struct wpa_ssid *ssid = wpa_s->current_ssid; int ret = 0; + /* + * inspect if channel's been changed since initialized. + * i.e. DFS radar detection + */ + if (ifmsh->freq != params->freq.freq) { + wpa_s->assoc_freq = ifmsh->freq; + ssid->frequency = ifmsh->freq; + if (hostapd_set_freq_params(¶ms->freq, + ifmsh->conf->hw_mode, + ifmsh->freq, + ifmsh->conf->channel, + ifmsh->conf->ieee80211n, + ifmsh->conf->ieee80211ac, + ifmsh->conf->secondary_channel, + ifmsh->conf->vht_oper_chwidth, + ifmsh->conf->vht_oper_centr_freq_seg0_idx, + ifmsh->conf->vht_oper_centr_freq_seg1_idx, + ifmsh->conf->vht_capab)) { + wpa_printf(MSG_ERROR, "Error updating mesh frequency params."); + wpa_supplicant_mesh_deinit(wpa_s); + return; + } + } + if (wpas_mesh_init_rsn(wpa_s)) { wpa_printf(MSG_ERROR, "Init RSN failed. Deinit mesh..."); wpa_supplicant_mesh_deinit(wpa_s); -- 2.7.4 _______________________________________________ Hostap mailing list Hostap@xxxxxxxxxxxxxxxxxxx http://lists.infradead.org/mailman/listinfo/hostap