On Wed, Apr 27, 2016 at 04:18:23PM +0200, Xue Liu wrote: > I use trunk for board. I would like to add WPS to it. The Clearfog > board is working as Access Point enabling WPA2-PSK and WPS Push > Button. The hostapd is started from shell with -dd and the > configuration file from https://wireless.wiki.kernel.org/en/users/drivers/ath10k/configuration > . After the AP started, I enable the WPS by| > | > > hostapd_cli wps_pbc Which version of hostapd are you using? > root@OpenWrt:~# hostapd -dd hostapd.cfg > Configuration file: hostapd.cfg > [ 2795.008571] IPv6: ADDRCONF(NETDEV_UP): wlan0: link is not ready > [ 2795.016774] device wlan0 entered promiscuous mode > wlan0: interface state UNINITIALIZED->COUNTRY_UPDATE ... This does not look like complete debug information. OpenWrt has a custom patch that makes debugging much more difficult by default. Could you please re-run this with a build that actually enables debugging in hostapd? I'm not sure how this is supposed to be done in OpenWrt, but the patch that breaks this is package/network/services/hostapd/410-limit_debug_messages.patch so either that would need to be removed from the build or the CONFIG_MSG_MIN_PRIORITY value would need to be defined somewhere in the build configuration to allow proper debugging. -- Jouni Malinen PGP id EFC895FA _______________________________________________ Hostap mailing list Hostap@xxxxxxxxxxxxxxxxxxx http://lists.infradead.org/mailman/listinfo/hostap
