Hi, I am using wpa_supplicant + dbus to connect my device to Access point, scan access points, disconnect from access points. If I send a scan command, when there is a problem connecting to the access points, My scan list is empty. The sequence is as below, My device connected to a access point successfully. After a while, switched off the access point, and my software tries to reconnect when there is a disconnect signal at 30 seconds interval (unless user has disabled wifi). At this period if I try to scan the wifi networks my scan list is empty. When i send wpa_cli -iwlan0 status it shows the wpa_state as SCANNING. I could see there is no scan_done signal received from dbus with dbus-monitor How to fix this? Regards, Johncy. _______________________________________________ Hostap mailing list Hostap@xxxxxxxxxxxxxxxxxxx http://lists.infradead.org/mailman/listinfo/hostap